When to replace torque converter on 2012 Honda CRV?
Hi, anyone have some information on the cost to replace the torque converter on a 2012 CRV in southwestern Ontario….likely would be taking it to a dealer. Shuddering last summer on 2-3 shift. Programming upgrade done 2015 and trans fluid changed again in 2017.
What causes a Honda CRV to stall out?
Here are some of the issues that cause the CR-V to stall out. Remember, a vehicle needs air, fuel, and spark to run. It needs them in the right quantities and intervals, or it won’t run right. Fuel issues are one of the most common reasons that a vehicle would stall out, that includes your Honda CR-V. Bad gas- can cause an engine to stall out.
What should I do about my Honda CRV front suspension?
2002-2006 Honda CRV front struts with sway/stabilizer bar links. 2002-2006 Honda CRV control arms and ball joints. Here is a list of the special tools you’ll need for this project. The short video below shows you these tools in action.
Why does my Honda CRV have a shudder?
Programming upgrade done 2015 and trans fluid changed again in 2017. Ten months and 18,000kms later shudder is back. Apparently this is a common problem. Planning on changing the trans fluid again just to see what happens. Any information is appreciated. Update – changed transmission fluid and shudder has disappeared again.
What are the torque specs for a Honda CRV?
Gen I – FRONT Link Nuts (Ball Stud Type) Type: 16 192 21.69 Gen I – FRONT Link Nuts (Rubber Bushing Type) Type: 16 192 21.69 Type: 25 300 33.9 Type: 11 132 14.91 Type: 7 84 9.49 Type: 36 432 48.81 Gen I – FRONT Caliper Guide Pins Type: Caliper Mounting Bracket To Steering Knuckle 83 996 112.53 Type: 47 564 63.72 Type:
2002-2006 Honda CRV front struts with sway/stabilizer bar links. 2002-2006 Honda CRV control arms and ball joints. Here is a list of the special tools you’ll need for this project. The short video below shows you these tools in action.
Why does my Honda CRV make a clicking noise?
Answer: The noise is from worn out liquefied CV axle grease or worn out CV bearings in the CV inner or out cage. In the absence of high-speed centrifugal force (slow wheel rotation), when a bearing reaches it’s peak, it drops into in CV cage when the cage advances ahead of the bearing. That’s what’s causing the clicking sound.
How does a Honda CRV lower ball joint adapter work?
A lower ball joint press adapter made especially for the shape of the Honda steering knuckle. It consists of three pieces. Two fit over the steering knuckle and ball joint and let you press the ball joint out; the third piece helps you press the new ball joint in.