When to adjust horizontal aiming on a Hyundai?
Horizontal aiming must be adjusted by an authorized Hyundai dealer to avoid incorrect alignment that will reduce the effectiveness of your headlights. If the vehicle has had front body repair and the headlight assembly has been replaced, the headlight aiming should be checked using an aiming chart as shown in the illustration.
How to adjust the headlight aiming on a Hyundai Tucson?
Before performing aiming adjustment, make sure of the following. 1. Keep all tires inflated to the correct pressure. 2. Place the vehicle on level ground and press the front bumper & rear bumper down several times. Place vehicle at a distance of 118 in. (3m) from the test wall. 3.
Where are the headlights supposed to be in a Hyundai?
Park the front of your SUV on a level surface with your headlights facing a wall at least 6 feet high and 12 feet wide. The front of the SUV should also be 25 feet from the wall. Measure the distance from the center of each headlight to the ground.
What should I use to adjust the aiming of my headlights?
Adjust each cut-off line of the low beam to the parallel line with a phillips screwdriver – VERTICAL AIMING. Never attempt to adjust the horizontal alignment of your headlights. Horizontal aiming must be adjusted by an authorized Hyundai dealer to avoid incorrect alignment that will reduce the effectiveness of your headlights.
Horizontal aiming must be adjusted by an authorized Hyundai dealer to avoid incorrect alignment that will reduce the effectiveness of your headlights. If the vehicle has had front body repair and the headlight assembly has been replaced, the headlight aiming should be checked using an aiming chart as shown in the illustration.
Adjust each cut-off line of the low beam to the parallel line with a phillips screwdriver – VERTICAL AIMING. Never attempt to adjust the horizontal alignment of your headlights. Horizontal aiming must be adjusted by an authorized Hyundai dealer to avoid incorrect alignment that will reduce the effectiveness of your headlights.
How do you adjust the headlights on a Hyundai?
Turn your low beam headlights on and check the aim against the marks on the wall. Use a Philips or Torx screwdriver to twist the screws. Adjust each headlight until the beams hit the marks on the wall. Ideally, you want the highest intensity zone of the lights to be slightly lower and to the right of the marks.
Where to aim headlight bulb on Nissan Elgrand Fixya?
If you have two nuts on each, one will adjust the vertical and the other will adjust the horizontal. If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall. You can’t post conmments that contain an email address.