When I press the gas my car stops?
The car will stall if the valve is too clogged or when it finally fails. If, while holding the accelerator pedal down, a small amount of pressure keeps the car running at a stop, the idle control valve may require attention. In most late model cars, this problem will usually trigger the Check Engine light.
Why does my Mitsubishi Galant stall when in neutral?
I have a Mitsubishi Galant 2003. Recently it has began to stall out when I turn the air conditioner on. If it is in Neutral or park it runs just fine. But once in Drive and stopped it wants to stall out and does at times. It will run fine when you are going but the gas also is acting funny.
Why does my Mitsubishi Galant engine surge at idle?
Car runs fine once she is going but at idle the engine seems to surge/buck forward when idling at a stop sign or red light.
How much does it cost to repair a Mitsubishi Galant?
The average cost for a Mitsubishi Galant General Diagnosis is between $88 -$111. Learn More Good news! We found 31 RepairPal Certified shops near you. Here’s a few you can book directly with. I have a Mitsubishi Galant 2003. Recently it has began to stall out when I turn the air conditioner on. If it is in Neutral or park it runs just fine.
How can I check the vibration in my Mitsubishi Galant?
Place the shifter into Drive and watch the change in the vibration. It should not become excessive. The same check can be done with the drivers door open watching the rear top corner of the door.
Car runs fine once she is going but at idle the engine seems to surge/buck forward when idling at a stop sign or red light.
How can I tell if my Mitsubishi Galant is working?
Mitsubishi Mechanic: Doug, ASE Certified Technician replied 8 years ago There aren’t any real easy ways to identify 100% however you can get a good idea with a few checks. Open the hood and start the engine. Watch the edge of the hood to note the vibration. Place the shifter into Drive and watch the change in the vibration.
What does p0135 mean on a Mitsubishi Galant?
P0135 is indicating an electrical fault in the front O2 sensor heater. It is not indicating any problem with the sensors ability to function as needed, only that the heater circuit inside (that brings it up to operating temperature faster for emissions reasons) is failed.
How big is the throttle plate on a Galant?
On the throttle body there is a metal plate held on with two screws. It is about 2 inches long and about 3/4 inch wide. Underneath is a sealing O ring in a groove.