When does the thermostat open on a Mercedes?
Only when the operating temperature is reached, do you get the best fuel efficiency and minimal wear on the engine. At wat temperature does the thermostat open up on a Mercedes-Benz engine? While this can vary, in the E320 and C240, for example, the thermostat opens up at 87-degree Celsius.
Where is the thermostat sensor on a Mercedes E350?
The sensor is typically found on 2008,2009,2010 and newer models such as C300 and E350. Remove the thermostat from the engine block. If the thermostat doesn’t come loose, you may need to pry it away using a flat screwdriver.
How do you replace a Mercedes thermostat in reverse order?
Install the new thermostat in reverse order. Ensure that you have a new gasket for your thermostat. The old gasket should be removed and discarded. Tighten the two bolts and reconnect the radiator hose. Do not overtighten the two bolts. If you have a torque wrench, you can tighten these two bolts to approximately 10Nm.
How do you remove a thermostat from a car?
Loosen the radiator hose clamp. Use theE-Torx socket to remove the two thermostat bolts. Unplug the electrical connector from the sensor if your car has one. The sensor is typically found on 2008,2009,2010 and newer models such as C300 and E350.
How do you replace the thermostat on a Mercedes Benz?
To replace the thermostat, you will need to drain some coolant from the radiator. At the bottom of the radiator of your Mercedes-Benz there should be a drain plug.
The sensor is typically found on 2008,2009,2010 and newer models such as C300 and E350. Remove the thermostat from the engine block. If the thermostat doesn’t come loose, you may need to pry it away using a flat screwdriver.
Where is the coolant temperature sensor located on a Mercedes Benz?
Replacing the coolant temperature sensor is a relatively easy job if you have a lot of patience. The sensor itself is located below the air pump and between the thermostat and coolant pump housing. The sensor is actually held in place by a small clip that sits in a channel created by both the thermostat on one side and coolant pump on the other.
How to change coolant in Mercedes Benz W203?
The cover is held on by five clips (red arrows) and will easily come off with hand pressure. Locate the tensioner and using the Torx driver turn it counter-clockwise 45 degrees. You can now slip the belt off the tensioner and install the new one.