When does p0353 ignition coil C primary or secondary?

When does p0353 ignition coil C primary or secondary?

The coil driver circuit is monitored by the PCM for faults If an open or a short is detected in the driver circuit for coil number 3, a P0353 may set. Also, depending on the vehicle, the PCM may also shut down the fuel injector to the cylinder also.

What causes an OBD code of p0353?

Several problems may cause a P0353 code including: A damaged or defective ignition coil. Damaged, defective, or corroded ignition coil connector. Damaged, defective, shorted, or corroded ignition coil driver circuit wiring. Loose connection at coil. Broken connector locks.

What is the other wire on a p0354?

The other wire is the coil driver circuit from the PCM. The PCM grounds/ungrounds this circuit to activate or deactivate the coil. The coil driver circuit is monitored by the PCM for faults If an open or a short is detected in the driver circuit for coil #4, a P0354 may set.

How to repair a DTC p0352 ignition coil?

Find the short and repair it. If there is no voltage on the driver circuit, then turn the ignition off. Disconnect the PCM connector and check the continuity of the driver between the PCM and the coil. If there is no continuity repair the open or short to ground in the circuit.

The coil driver circuit is monitored by the PCM for faults If an open or a short is detected in the driver circuit for coil number 3, a P0353 may set. Also, depending on the vehicle, the PCM may also shut down the fuel injector to the cylinder also.

Several problems may cause a P0353 code including: A damaged or defective ignition coil. Damaged, defective, or corroded ignition coil connector. Damaged, defective, shorted, or corroded ignition coil driver circuit wiring. Loose connection at coil. Broken connector locks.

The other wire is the coil driver circuit from the PCM. The PCM grounds/ungrounds this circuit to activate or deactivate the coil. The coil driver circuit is monitored by the PCM for faults If an open or a short is detected in the driver circuit for coil #4, a P0354 may set.

When to look for the p0351 DTC code?

The P0351 DTC is seen when the ignition coil A primary or secondary circuit has a malfunction. The engine control module is looking for specific signals from the ignition coil A and when these signals are not seen the ECU sets the Check Engine Light.