When do you need to replace the gasket on a Saturn?
The gasket on the exterior of the manifold helps seal off any leaks running from the manifold itself. If the gasket is ever cracked or damaged you will need to replace it, as it may otherwise start leaking fuel and other liquids from your Saturn. Kill the engine on the Saturn and pop the hood.
Where does the fuel line go in a Saturn’s / 1?
On vehicles that use a fuel injection system — including the Saturn S/1 SOHC — the fuel line runs into the engine via an intake manifold. The gasket on the exterior of the manifold helps seal off any leaks running from the manifold itself.
How do you replace intake manifold in Saturn?
Slide the new intake manifold gasket into position but be extremely careful to not put it in at an angle as this is going to crack the gasket, forcing you to find a new replacement. Tighten the bolts back into position and close the hood of your Saturn.
Are there any problems with the Saturn’s series?
Saturn experimented with making these out of plastic, it was a huge failure. ALL of them failed, if you still own one of these cars and it hasn’t been replaced, it has failed. Symptoms include hard starting, rough idle, temperature gauge not working, awful fuel economy, poor performance, and stumbling, among many other things.
What causes a Saturn’s to slam into reverse?
This causes the car to “slam” into reverse and/or harsh upshifts, depending on which is worn. It will eventually destroy the line pressure solenoid, which will make for very hard upshifts. If left for a while, it will knock the input shaft nut loose, further worsening the condition of the shifts.
Why are my coil springs broken on my Saturn s?
-Broken coil springs in 3rd generation (00-02) cars. If you’re doing struts, replace the springs. OE junkyard replacements from a gen-1 or gen-2 car are your best bet. This is caused mainly by overdrawing from the 12v socket, or high power aftermarket accessories drawing from the same circuit.
Why is my fuel pump not working on my Saturn s?
This is caused mainly by overdrawing from the 12v socket, or high power aftermarket accessories drawing from the same circuit. There will be melted plastic around the fuse. The radio, chime module, dome light, 12v socket, and fuel pump are on this circuit. You will probably know about it when the fuel pump stops working.
How do you get a gasket out of a car?
Twist the torque wrench and the nut inside helps spin the wrench, which helps remove the bolt. Once the bolt is out repeat the same process with the other bolts on the gasket. With all the bolts removed you can slide out the gasket.