When did the Jeep Wrangler Rubicon engine shut off?
Monday, January 11, 2016 4:21 pm transmission fire. 2011 Jeep Wrangler rubicon with 81k miles all maintenance. No modifications and no off roading. Lost power on an inclined road.
Why does my speedometer not work with a new sensor?
Had check engine light come on. Ran codes came up with p1692 speedo sensor. Put new sensor and still speedometer will not work. Any suggestions please. I dont want to buy a new pcu unless I have to.
What should I do if my Jeep Wrangler wont start?
If the battery seems to be intact, you cannot identify the noises your engine makes when it is started and you cannot discover any defective cables or an empty tank, you should leave the diagnosis to experts. In the workshop, a mechanic can probably find out what the problem is in no time and then get rid of it.
How much does it cost to repair a speedometer?
He said that the speedometer itself went bad and needed to be rebuilt (they don’t make replacements anymore) with a total repair cost of about $500. Welcome @corderm .
Had check engine light come on. Ran codes came up with p1692 speedo sensor. Put new sensor and still speedometer will not work. Any suggestions please. I dont want to buy a new pcu unless I have to.
He said that the speedometer itself went bad and needed to be rebuilt (they don’t make replacements anymore) with a total repair cost of about $500. Welcome @corderm .
How to reset your Jeep engine control module?
3- Once the time has passed you should now turn the headlights “on” and “off” twice to drain the Engine Control Module from any remaining power. 4- Now plug back in the negative terminal and your Jeep ECM should now be reset. To finish off this post , here are a couple of things you should keep in mind.
How often should I Reset my Jeep ECM?
For good measure. Anytime that you reset your Jeep PCM you should keep in mind that you will need to drive your car for approximately 10-15 miles so your Jeep ECM can re-learn your driving habits and fuel management. Good luck with your reset and be sure to share this with anyone that might be in need of it!
Monday, January 11, 2016 4:21 pm transmission fire. 2011 Jeep Wrangler rubicon with 81k miles all maintenance. No modifications and no off roading. Lost power on an inclined road.
What happens when you shut off the engine in a Jeep Wrangler?
Vehicle shuts down completely. The interior still has power but the power steering and engine stops. It restarts but act like it is not getting any fuel. It runs fine after it is cranked until the next time it happens. It is very dangerous as. See all problems of the 2015 Jeep Wrangler .
What kind of problem does a 2010 Jeep Wrangler have?
The contact owns a 2010 Jeep Wrangler. While driving 40 mph, smoke emerged from the vehicle and there was an abnormal burning odor coming from the vents. The contact observed grass and mud underneath the vehicle. There were no warning indicators illuminated.
Where is the failure code on a 2010 Jeep Wrangler?
The contact owns a 2010 Jeep Wrangler. When the vehicle was driven for approximately ten minutes, it overheated and the check engine indicator illuminated. The vehicle was taken to an unknown Jeep dealer in manhattan, NY where failure code: P1745 was located.