When did the Hyundai Tucson fuse box come out?
In this article, we consider the first-generation Hyundai Tucson (JM), produced from 2004 to 2009. Here you will find fuse box diagrams of Hyundai Tucson 2004, 2005, 2006, 2007, 2008 and 2009, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay.
What to do if your radio wont turn on?
Take some small gauge wire directly to the battery terminals, and connect to the correct pins on your radio harness/plug (yellow for power, black for ground). See if it even turns on with direct power. Rule out the HU itself first. EDIT, just read the above post.
Where is the fuse box on a Hyundai Sonata?
The fuse box is located on the driver’s side of the instrument panel, behind the cover. The fuse box is located in the engine compartment (left-side). Not all fuse panel descriptions in this manual may be applicable to your vehicle. It is accurate at the time of printing. When you inspect the fuse box on your vehicle, refer to the fusebox label.
Where are the fuses on a Hyundai Tiburon?
Click to expand… remove the BCM & fuse panel cover directly in front of your left knee, then get down and look towards the top left side of the BCM and you will see the yellow fuse cover. pull it out and flip the top up to access the fuse itself. (the yellow cover doesnt come out all the way).
What are the fuse boxes on a Hyundai Tucson?
BCM, Auto Light & Photo Sensor, Room Lamp, Driver/Passenger Vanity Lamp Switch, Date Link Connector, Door warning Switch, RF Receiver, A/C Control Module, Luggage Lamp, IPS Control Module, Instrument Cluster (IND.), Map Lamp, Electro Chromic Mirror Instrument Cluster (Air Bag IND.)
What happens when a car radio fuse is blown?
In the case of your car radio fuse, it is designed to sacrifice itself to prevent a dangerous amount of current from flowing through your car radio and the associated circuit. If your radio is dead due to a botched jump start or charge, and you’re lucky, then you may find that your car radio fuse is blown.
Click to expand… remove the BCM & fuse panel cover directly in front of your left knee, then get down and look towards the top left side of the BCM and you will see the yellow fuse cover. pull it out and flip the top up to access the fuse itself. (the yellow cover doesnt come out all the way).
Where is the fuse box on a Santa Fe?
The fuse box is located in the instrument panel (on the driver’s side), behind the cover. The fuse box is located in the engine compartment (left-side). Inside the fuse/relay panel covers, you can find the label describing fuse/relay name and capacity. Not all fuse panel descriptions in this manual may be applicable to your vehicle.
In this article, we consider the first-generation Hyundai Tucson (JM), produced from 2004 to 2009. Here you will find fuse box diagrams of Hyundai Tucson 2004, 2005, 2006, 2007, 2008 and 2009, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay.
Why is my Hyundai blower motor not working?
The resistor going bad is a fairly common problem which is easily fixed though it is an issue which is often missed. If this does not resolve the problem then check if there is a problem with the outside ambient air temperature sensor. If this shorts it breaks the circuit and the AC will not work.
Which is fuse on a manually controlled Hyundai Sonata?
Which fuse on a manually controlled Hyundai Sonata protects the blower motor? Check the fuse in the fuse box rated at 30 amps which is for the Blower. Also check the fuse on location 5 of the interior fuse box rated at 10 amps. If both fuses are good then check the blower motor relay which might need to be replaced.
What causes a fuse to blow on a blower motor?
If the blower motor relay develops any sort of problem that hinders its ability to properly limit and distribute power, it may cause the blower motor fuse to blow. Any sort of electrical spikes or excessive current from a bad relay will blow the fuse and cut power in order to protect the system.