When did the Ford AOD transmission come out?
The Ford AOD automatic overdrive four-speed transmission, introduced in 1980, was used with most Ford engines of the day. Ford later introduced the AODE, a computer-controlled version of the AOD.
Where is the electrical plug on a Ford AODE transmission?
AOD, AODE and 4R70W transmissions all have the same pan shape, illustrated on Fordification.com’s AOD section on the Automatic Transmission Identification page. Look for the electronic cable and electrical plug. AODE and 4R70W transmissions have a plug on the driver’s-side rear of the transmission housing.
Where is the date code on a Ford overdrive transmission?
Ford Automatic Overdrive transmission is slightly different. Date codes are sometimes included in sections. They are found in various areas and usually consist of 3 or 4 digits. DATE CODE Some parts may include a date code that indicates when the part was produced.
Where is the Pan located on a Ford AODE transmission?
The transmission is under the center of the vehicle, immediately behind the engine. The pan is located on the bottom of the transmission and attached by 14 bolts. AOD, AODE and 4R70W transmissions all have the same pan shape, illustrated on Fordification.com’s AOD section on the Automatic Transmission Identification page.
The AOD transmission is a Ford model that was introduced in 1962 aimed at emphasizing fuel economy and durability. While many transmissions of the time had a fourth gear installed as a basic afterthought only there for minimal purpose, the AOD was designed as having the fourth gear as an integral part…
Is the AOD transmission a bulletproof car?
The Ford AOD transmission shifting problem, therefore, gave it its unreliable performance reputation. Nonetheless, it wasn’t all bad things since there are features that will enable the Ford AOD to become a bulletproof transmission some car fanatics have been talking about all the while.
What’s the AOD ratio on a 1992 Ford truck?
Some SVO-tuned Mustangs and some 1992 and ’93 trucks came with a wide-range AOD, which had these ratios: 1st, 2.84:1; 2nd, 1.55:1; 3rd, 1.00:1; OD, 0.67:1; Reverse, 2.00:1.
Do you need a dust cover for an AOD transmission?
The AOD and C4 transmissions use different block plates primarily because they are different transmissions with two different-size flexplates. This means you need an AOD-specific block plate and dust cover for the 164-tooth flexplate.
The AOD (for automatic overdrive) is a four-speed automatic transmission with overdrive. Introduced in 1980, it was Ford’s first four-speed automatic overdrive transmission. The gearset design is based on the Ford “X” automatic transmissions used during the 1950s, 60s and 70s.
Why is my AOD transmission not shifting out of first gear?
If the governor is sticking it will cause a delayed, or no upshift, depending on how bad the condition causing the sticking is. If the 1-2 shift valve is stuck, and will not stroke, the transmission will not shift out of first gear. To top I just put an 85 AOD transmission in a 1995 F150.
What’s the throttle point on an AOD transmission?
It sounds like you don’t have a TV cable hooked to the transmission. If the TV cable is not connected the transmission will default to full TV pressure. If TV pressure is full shifts will only occur at the wide open throttle shift point, which is usually around 4900 RPM.