What years was the Kawasaki Prairie 360 made?
The Kawasaki Prairie 360 4×4 is a utility ATV produced from 2003-2013 as a compact version of the Prairie 650. Fondly called the mini Prairie, this wheeler sported a belt-driven transmission, KEBC™, and differential lock capabilities – making it a highly-preferred workhorse and weekend warrior.
How much is a 2003 Kawasaki Prairie 360?
The new Prairie 360 4×4 utilizes much of the same technology found on the Prairie 650 4×4, but with its single-cylinder engine displacing 362cc, it is targeted toward the mid-size 4×4 segment…
How do you reset the belt light on a 2004 Kawasaki Prairie 700?
To reset, turn ignition off and pull cvt cover. Put switch inside cover back into “on” postion. Remove seat and disconnect the 2 connectors grey and black and reverse them. They are located if sitting on quad in right rear corner.
Is the Prairie 360 4 wheel drive working?
I have a 2003 Prairie 360 4X4 that is having 4 wheel drive problems. My problems is that it is currently in 4wd but will not dis-engage. I removed the actuator and verified that it is working.
What’s the speed of a Kawasaki Prairie 360?
Starts just fine and idles fine. Just no speed does about 15-20 mph. I am assuming due to belt and being in limp mode. Also noticed it takes a second or two to get going once i place i gear. Would like to get it running right and start using it more.
What to do if your ATV wont go into gear?
Troubleshooting an ATV that won’t go into gear or won’t shift gears can be quite complicated, but not always. Whether you’ll be able to address the issue on your own depends on the severity of the problem as well as your mechanical skill level.
What causes an ATV engine to wear out?
Sucking dirt particles into the engine will, over time, wear out the engine and can do some serious damage. Here’s the basic break down: an engine needs both fuel and air to produce power.
I have a 2003 Prairie 360 4X4 that is having 4 wheel drive problems. My problems is that it is currently in 4wd but will not dis-engage. I removed the actuator and verified that it is working.
What causes a Kawasaki Prairie 360 to stall?
Would that be the cause of the engine stalling when i put it in gear i put it in 4×4 on jack stands and its engaging. So four wheel drive is working. My cell is XXXXXXXXXX if thats quicker to contact me. did you measure the resistance between the red to black, yellow to blue and orange to blue on the engine braking controller?
What are the numbers on a Kawasaki Prairie 360?
The red and black on the 4×4 actuator was 13-16 with both symbols, orange and blue was 15-17.5 with both symbols and the yellow and blue was 16-18 with both symbols. when I had the tester connectwd the numbers kept jumping around. Let me know your thoughts and or the next steps.
What kind of CARB dip do you use on a Kawasaki Prairie 360?
I recommend the Yamaha carb dip because it works and it will not affect rubber part like most carb cleaners will. Yamaha’s Carb Dip needs to be mix 50/50 with warm water. After you dip the carb it will need the all jets and passages verified with spray carb cleaner to make sure the fluid will make it through the intended passage.