What to use to replace valve cover gasket?
Replacing the valve cover gaskets is an easy job that you can tackle yourself. Spark Plug Boot removal tool (Optional). It will make your job easier. 3/8 Torque Wrench that will do 8 Nm, 6 ft.lbs like this one.
When to replace valve cover gasket on Mercedes Benz?
Step by step instructions on how to replace the valve cover gasket on Mercedes Benz V6 and V8 engines found on the E Class, C Class, ML Class and many other models. When the valve cover gasket starts to leak oil it will drip on top of the exhaust manifold.
What kind of wrench do you need to tighten a gasket?
Place the valve cover with the new gasket back in place. Hand tighten all the bolts by hand first. Once you hand tighten all the bolts, you will need a torque wrench to tighten the bolts. You need to tighten the bolts to 8 Nm or 70 inch pound. That is not much force at all.
How do you fix a gasket leak on a Mercedes?
Lift the cover up on one side about a couple of inches so it gets loose. Then lift the other side just a little bit. Now grab the cover on both sides and lift it up. It is not bolted down, it is held in place with a few clips. Locate the passenger valve cover. Towards the back of the valve cover gasket you will notice a black plastic tube.
What are the symptoms of a failing valve cover gasket?
You can ignore the symptoms of a failing valve cover gasket for a while. However, if you let it go too long, it can result in costly damage. Some of the major symptoms are: Low oil level/oil leaks – This is one of the easiest ways to tell if you have a failing valve cover gasket.
How to access AutoZone’s torque specifications repair guide?
Find out how to access AutoZone’s Torque Specifications Repair Guide for Grand Prix, Impala 2006-2008, Monte Carlo 2006-2007. Find out how to access AutoZone’s Torque Specifications Repair Guides.
How do you remove the valve cover on a BMW N51?
On the N51 and N52N engines, there are metal spark plug sleeves which help seal off the spark plug tubes. These sleeves are one time use only and must be removed to have enough room to remove the valve cover. Using a pair of snap ring pliers, squeeze the gap in the sleeves together and pull them out.