What to do if your golf cart controller is not working?
Pull the governor near the carburetor and then check its attachment. If the governor near the carburetor is moving and is not attached near the carburetor or is not moving at all, it is bad in both cases. In both cases, you need to replace the controller.
Where is the speed controller on a golf cart?
Locate the speed controller on the engine. It is placed on the gold cart motor near the engine. Locate the governor near the carburetor of the engine. It is a T-shaped rod and checks its attachment. Pull the governor near the carburetor and then check its attachment.
Why is the EZGO golf cart controller important?
Golf cart controllers play an important part in which its main job is to control the speed of a golf cart. However, many times, the controller tends to act up or simply stops working. This is when it is very important to troubleshoot the problem immediately. Known as the heart of the EZGO golf cart, the controller’s core objective is to …
How do you change an idle air control motor?
Step 1 – Locate and remove the air intake bore which is attached to the throttle bore and is usually done be loosening the mounting clamp. (Note: some idle air control motors can be replaced without removing the throttle bore.)
How to install a choke control on a carburetor?
Insert the cable bowden wire into the choke control (front or reverse pull). Then place choke cable under the cable clamp. 3. Position the choke control so it bottoms, then pull it back approximately 1/16″ (1.5 mm). Make sure that the carburetor choke is fully opened before tightening cable clamp. 4.
When do I need to replace my carburetor?
If your engine is hesitating, stumbling, stalling, letting out black smoke, or has a hard time starting you may need to replace the carburetor. As intimidating as it may look, replacing a carburetor is an easy task that can be completed in just a few steps. Below is a guideline to help you replace your carburetor.
How do you replace a gas tank carburetor?
2. Remove the air filter and the four bolts holding the air filter base on. 3. Remove the two bolts holding the muffler on and remove the complete muffler. 4. Remove the two screws holding the choke/throttle control on the gas tank. Move the assembly to the side. 5.
How to remove pressure regulator from carburetor?
Unplug pump-gauge-sender-connector, and remove the torx screws. Find plastic-hose that goes from pressure regulator to tank outlet, and cut that hose off. Don’t let any particles fall into the tank. You can now remove the tank outlet fitting and take out the hose. Cut hose and reinstall tank outlet fitting.