What to do about no start Mazda6?
Note: 2006-07 Mazda6 vehicles already have a modified fuel pump relay. 1. Record the customer’s pre-seat radio stations. 2. Disconnect the negative battery cable. 3. Disconnect the air flow sensor connector. 4. (3.0L Engine Only): Disconnect the VAD three-way solenoid connector. 5. Remove the air cleaner.
How do you remove electrical harness from Mazda 3?
To remove the wiring harness from the clip in the engine room, pry up the hook of the clip using a flathead screwdriver. Do not remove the harness protective tape. Otherwise, the wires could rub against the body, which could result in water penetration and electrical shorting. When disconnecting connector, grasp the connectors, not the wires.
How do you remove battery from Mazda 3?
Before disconnecting connectors or removing electrical parts, disconnect the negative battery cable. To remove the wiring harness from the clip in the engine room, pry up the hook of the clip using a flathead screwdriver. Do not remove the harness protective tape.
How do you remove a terminal from a Mazda CX 5?
Use the appropriate tools to remove a terminal as shown. When installing a terminal, be sure to insert it until it locks securely. Insert a thin piece of metal from the terminal side of the connector and with the terminal locking tab pressed down, pull the terminal out from the connector. Handle sensors, switches, and relays carefully.
Note: 2006-07 Mazda6 vehicles already have a modified fuel pump relay. 1. Record the customer’s pre-seat radio stations. 2. Disconnect the negative battery cable. 3. Disconnect the air flow sensor connector. 4. (3.0L Engine Only): Disconnect the VAD three-way solenoid connector. 5. Remove the air cleaner.
What was the problem with my Mazda 6?
Turns out this is a very common problem with all first generation Mazda 6 cars: The Fan Control Module (FCM) has a high failure rate. I replaced my FCM and it solved this problem.
How to reprogram Mazda 6 service manual immobilizer?
After approx. 1 minute DTC B1601 (DTC 15) is output (1) Perform security access approval. (See Security Access Procedure.) (2) Select “Ignition Key Code Erase”. Do not select any other command from this menu. (3) Turn key 1 to LOCK position for more than 1 second. (4) Turn key 1 to ON position for more than 1 second. DTC B1213 (DTC 21) is output.)
Can a Mazda 6 PCM be changed from another car?
This is because the previously programmed key IDs are erased when reprogramming the key IDs into the PCM. The PCM cannot be changed from one car to another. If an PCM is replaced with one from another car, the engine will not start. The PCM should not be newly replaced as a trial during troubleshooting.