What should you follow when removing and refitting the starter motor assembly?
Turn off the ignition and remove the negative battery cable from the battery. Remove the positive cable (the large cable that runs to the battery) from the starter. Disconnect all the bolts that hold the starter to the block, using a ratchet. Remove any other supporting brackets holding the starter in place.
When does the ignition switch need to be set?
The ignition switch needs to be set to the accessory position before you can release it from the ignition module. The “accessory” position is before the starter is engaged, and would normally let you run the vehicle’s electronics without the engine running (when the battery is connected).
Is it possible to rebuild an ignition switch?
Only some dealerships will rebuild an ignition switch and they often can’t for all vehicles, so rebuilding yours may not be an option. In that case, you will need to get a new switch from a manufacturer specific dealership that will also provide you with new ignition keys to match.
Where is the release pin on an ignition switch?
The new or rebuilt switch should slide easily back into its hole on the steering column. Align the shape of the cylinder and the location of the release pin with the coinciding grooves in the ignition module.
How to test a new ignition lock cylinder?
Step 10: Test the operation of the new ignition lock cylinder. Before you reconnect the battery, make sure your new ignition lock cylinder moves to all four positions with the new key. Test this function three to five times to verify the repair was completed correctly.
How to install ignition user manual 8.0 Quick Start Guide?
Quick Start Guide. 1 1. Download and Install Ignition. Installation is simple and can be done in under 3 minutes! Let’s get started and install now. Find more information 2 2. Launch the Gateway Webpage. 3 3. Connect to a Device. 4 4. Connect to a Database. 5 5. Open the Designer.
How long does it take to install ignition?
Download and Install Ignition Installation is simple and can be done in under 3 minutes! Let’s get started and install now. Also, ensure you have Administrator privileges to run the Ignition installer. Select Download Ignition in the upper right corner of the page.
How do you remove ignition switch lock cylinder?
Removing the cylinder is the recommended way to thoroughly clean it, as opposed to blasting brake cleaner into the dash panel. The removal process is fairly straightforward. The aluminum cylinder cover ring needs to be rotated a quarter turn counter-clockwise while the key is in the “1” (Accessory) position.