What should the brake nut be on an AVA Voyager?
Tighten the rear axle nut to 80 ft/lbs. of torque and the brake caliper bolt to 72 ft/lbs. Your ready to ride!! Problem: You are noticing that your brakes, either front or rear, are starting to drag and/or what could be called moaning. It could also be felt as a minor but noticeable vibration while the moaning is taking place.
What kind of air filter do I need for my Voyager?
A STP SA3915 replacement air filter will fit perfectly into the Voyager OEM white plastic basket by trimming approximately 1/8″ off two opposite ends with a razor cutter. Apply silicon or other sealant in the bottom of the basket and place the wire side of the new filter down into the sealant.
What should the tire pressure be on a Voyager?
B. Heavier loads-dual riding and/or luggage (from 200 lb. total up to maximum motorcycle capacity stated in the owner’s manual)-pressure of 36 psi front and 40 psi rear must be maintained. Please Note: For any dual riding or fully loaded use, 40 psi must be maintained in all Dunlop rear tires fitted to touring motorcycles.
Where can I find Ava Voyager XII Tech Tips?
The newest 1200 Tech Tips may first be displayed in the AVA Members Group in the AVA Forum. Click Here to go to Page 1 of the Voyager XII Tech Tips. The Tech Center does not contain all available tech tips for the Voyagers, the most recent are contained in the hardcopy newsletters, with still others contained in the Tech Tips Manual.
Tighten the rear axle nut to 80 ft/lbs. of torque and the brake caliper bolt to 72 ft/lbs. Your ready to ride!! Problem: You are noticing that your brakes, either front or rear, are starting to drag and/or what could be called moaning. It could also be felt as a minor but noticeable vibration while the moaning is taking place.
A STP SA3915 replacement air filter will fit perfectly into the Voyager OEM white plastic basket by trimming approximately 1/8″ off two opposite ends with a razor cutter. Apply silicon or other sealant in the bottom of the basket and place the wire side of the new filter down into the sealant.
The newest 1200 Tech Tips may first be displayed in the AVA Members Group in the AVA Forum. Click Here to go to Page 1 of the Voyager XII Tech Tips. The Tech Center does not contain all available tech tips for the Voyagers, the most recent are contained in the hardcopy newsletters, with still others contained in the Tech Tips Manual.
What kind of lubricant do you use on Kawasaki Ava Voyager?
Do not use gasoline, motor oil, or any other petroleum distillate, as this will cause deterioration of the rubber parts. When lubricating these shafts, Kawasaki recommends using a Poly Butyl Cuprysil grease (PBC is a special high temperature, water resistant grease).
B. Heavier loads-dual riding and/or luggage (from 200 lb. total up to maximum motorcycle capacity stated in the owner’s manual)-pressure of 36 psi front and 40 psi rear must be maintained. Please Note: For any dual riding or fully loaded use, 40 psi must be maintained in all Dunlop rear tires fitted to touring motorcycles.