What should intake bolt torque be on aluminum heads?
So i installed my intake a few weeks back. Still havnt ran the motor. I have edelbrock aluminum heads and i torqued my intake down to 30 ft lbs. Well i seen today the papers for the heads said to torque to 25 ft lbs.
Do you need a TQ wrench for intake bolts?
Use ANTI-Seize on EVERY bolt and stud. You don’t don’t need a TQ wrench. 3/8″ ratchet, 9/16″ combination wrench power is enough TQ. Click to expand… Aside from intake and accessory holes the rest had heli coils when new. Intakes already on so im not taking if off to drill them out.
How to calculate the torque of a metric bolt?
TORQUE CONVERSION – Ft. Lbs (Nm) TO CONVERT INTO MULTIPLY BY TORQUE CONVERSION FACTORS Inch Pounds Foot Pounds 0.0835 Inch Pounds Newton Meters 0.1130 Inch Pounds Kg Meters 0.0115 Inch Pounds Kg Centimeters 1.1519 Foot Pounds Inch Pounds 12.000 Foot Pounds Newton Meters 1.3560 Foot Pounds Kg Meters 0.1382 Foot Pounds Kg Centimeters 13.8240
What’s the best way to lubed a torque table?
Lubricate all contact areas of the bolts and washers. Lubricating the bolts is the suggested method. Lubed means cleaned, dry bolts, lubricated with standard medium viscosity machine oil. Lubricate all contact areas of the bolts and washers. Lubricating the bolts is the suggested method. Nom Dia-Pitch Nom Size x Pitch INCH BOLT TORQUE TABLE
What are the ARP bolt torque specifications?
- Rod Bolts. Rod bolts with part no.
- and FBV8716 with 90 foot-pounds of torque using oil and 65 foot-pounds of torque using ARP lube.
- Cylinder Head Studs. Cylinder head studs with part no.
- Main Studs.
What is the head bolt torque specs?
Torque specs: Torque specs: CYLINDER HEAD BOLT TORQUE SPECS (tightening) / (loosening) 8, 4, 2, 6, 10 7, 3, 1, 5, 9. Torque in steps: 22ft-lbs (264in-lbs), Then to 63ft-lbs (756in-lbs) (final spec) 94+ Teg
What are the torque settings for head bolts?
SOURCE: head bolts torque settings According to my haynes manual for G-S reg, 1989-1998 it goes as follows, Stage 1:- Tighten all bolts by hand until bolt heads just contact cyl. head. Stage 2:-Tighten all bolts to 40Nm or 30lb ft. Stage 3:-Angle tighten all bolts a further 60 degrees. Stage 4:-Angle tighten all bolts again a further 60 degrees.
What is the torque on the cylinder head bolts?
torque the cylinder head bolts. Torque: 30 Nm (22 ft-lbs).