What should I remove from a transfer case?
These usually include: the front drive shaft, shifter linkage, 4 wheel drive sensor, and the rear drive shaft. Once these components are removed, you can then remove the transfer case. Be sure to use the heavy duty floor jack because the transfer case is extremely heavy.
How do you remove a transmission case from a car?
Unscrew the bolts that secure the transmission/transfer case assembly to the crossmember, using a socket. Position a transmission jack underneath the transfer case. Raise the jack enough to take the weight of the transmission/transfer case off the crossmember.
What do you need to open a transfer case?
Be sure to use the heavy duty floor jack because the transfer case is extremely heavy. In order to open the transfer case you will need to remove several bolts on the outer housing of the case. Once the housing cover for case is off, remove the retaining clip slide out the transfer case oiler from the shaft.
How do you remove a transfer case from an S10?
Pull the console cover away from the console and pull up the shift boot. Unscrew the shift lever to transfer case bolt, using a socket. Pull the shift lever upward. Unscrew the bolts that secure the transmission/transfer case assembly to the crossmember, using a socket. Position a transmission jack underneath the transfer case.
What to do when you remove transfer case?
Torque the bolts to 37 ft. lbs. Replace the skid plate and drive shafts back into place. If you marked the shafts, make sure to align them the same way that they were when you removed the old transfer case. Replace the transfer case fluid with an approved Ford transfer case fluid. If playback doesn’t begin shortly, try restarting your device.
How do you remove skip plate from transfer case?
Remove the bolts that hold the skip plate in place, and then set the plate aside. Locate the fluid drain plug or bolt on the transfer case, and then place the plastic drip directly underneath it. Open the plug and allow the fluid from the transfer case to drain into the pan until it is empty.
How to rebuild a car with a transfer case?
How to Rebuild a Transfer Case. 1 Step 1 – Purchase Transfer Case Rebuild Kit. Visit a local auto parts store or shop online for a rebuild kit that is compatible with your make and 2 Step 2 – Raise and Secure the Vehicle. 3 Step 3 – Remove Skip Plate. 4 Step 4 – Drain Transfer Case Fluid. 5 Step 5 – Removing the Transfer Case.