What kind of tubing does legup landingear use?
The wheel/leg system consists of 3/8-inch steel plate, 7/8-inch solid tubing, and 7/8-inch DOM tubing. The wheels articulate at the end of the legs on an axle with a large spring.
How much does it cost to install legup landingear?
Installation is a complete bolt-on affair. These are the components that make up the LegUp system that fits H-D Touring models ($2,995). Also included in the box are a 25-page installation manual that is full of pictures and a user’s manual.
How to change the landing gear on a Lippert?
Make sure it is oriented correctly regarding the bulged-out side of the leg, as shown in the diagram, and that you are inserting the shaft from the bulged-out side. Hold the gear against bushing, moving it around as you push on the drive shaft until things line up and shaft goes into and through gear.
Where is the control box on a legup landingear?
There is adjustment built into the aluminum mounts to allow critical alignment of the actuator. When the exhaust system is reinstalled, this actuator will move in and out between the swingarm and the left exhaust pipe, making the actuator almost invisible. 13. The control box seen here has two buttons and two LEDs.
How did I get my landing leg out of my truck?
Luckily I was still hooked to the truck so I set to work removing the faulty landing leg to try and determine the issue. Removing the trailers landing leg was pretty straight forward involving undoing just a few bolts, its foot pad and locking pin assembly. In no time I had the whole leg out.
What to do about broken fifth wheel landing leg?
I surmised that a small metal pin needed to be punched out to get the ball rolling sort of speak. Sure enough, once I punched out the pin on the top beveled gear and another below the larger lower beveled gear, the rest of the mechanism could be easily taken apart exposing the long worm gear.
Make sure it is oriented correctly regarding the bulged-out side of the leg, as shown in the diagram, and that you are inserting the shaft from the bulged-out side. Hold the gear against bushing, moving it around as you push on the drive shaft until things line up and shaft goes into and through gear.
How often should a landing gear be lubricated?
MAINTENANCE PROCEDURES These procedures must be performed, as needed depending upon application but at least every 3 months. Lubricate at least every 3 months and more frequently in applications where the landing gear are exposed to excessive moisture (liquid salt water spray), dust, or if they are not used for extended periods.