What kind of transmission does a 45RFE have?
The hydraulic control system design (without elec- tronic assist) provides the transmission with PARK, REVERSE, NEUTRAL, SECOND, and THIRD gears, based solely on driver shift lever selection.
What should I do when my transmission is removed?
Once the transmission is removed from the vehicle, contact several transmission repair shops and/or independent transmission technicians to obtain rebuild quotes for a “ bench job “. “Bench job” is the term used for a transmission rebuild only, not the labor to remove and install the transmission.
How do you replace a rear wheel drive transmission?
Easy to follow step by step guide on how to replace or remove an automotive manual (standard) transmission for rear wheel drive vehicles, though appearances may vary, the process is the same on most vehicles. Tools and Supplies Needed Hoist or hydraulic jack with stands.
What kind of case does a 45RFE / 545RFE come in?
The 45RFE/545RFE is packaged in a one-piece die-cast aluminum case. To reduce NVH, the case has high lateral, vertical and torsional stiff- ness. It is also designed to maximize the benefit of the structural dust cover that connects the bottom of the bell housing to the engine bedplate, enhancing overall power train stiffness.
When to rebuild a 45RFE or 545RFE transmission?
To rebuild 45RFE or 545rfe transmission after 300,000 kilometers or more it’s needed to replace the valve body and to inspect the condition of the drive shafts. Typically, the clutch drum is burned, forcing to produce a replacement of it.
Where was the Chrysler 545RFE 5 speed transmission made?
In 545RFE usage, an extra taller overdrive ratio is also used. Chrysler decided to refer to it as a “multi-speed automatic”. The 45RFE was produced at the Indiana Transmission plant in Kokomo, Indiana. It was normally paired with the 4.7 L PowerTech V8. The 45RFE later became the 5-speed 545RFE Helping each other make better choices.
How do you remove a transmission from a van?
Slide the drain pan under the transmission pan. Loosen the bolts (do not remove them yet), starting at the back of the pan and working your way toward the front. The pan will tip as the bolts are loosened, allowing the fluid to drain into the pan. Keep loosening the bolts until the fluid no longer spills out of the pan.
What kind of fluid is in a 545RFE transmission?
545RFE Fluid type and capacity. Capacity: 10.5-11 l. Fluid Type: MOPAR +4 or Dexron 3-6