What kind of oil does a Hyundai Santa Fe?
Engine Oil
| Viscosity: | 10W-30 (Above -18) 5W-20, 5W-30 (All TEMPS) SAE 5W-30 is preferred. |
|---|---|
| Capacity: | 5.1 quarts (with filter)After refill check oil level. |
| Torque: | 25-33 ft/lbs (Oil Drain Plug) Install a new washer on the drain bolt. |
What kind of oil does a Hyundai Santa Fe 2004 take?
Engine Oil
| Viscosity: | 5W-30, 5W-40 (Below 35) 10W-30, 10W-40, 10W-50 (Above -23) 20W-40, 20W-50 (Above 0) |
|---|---|
| Capacity: | 4.5 quarts (with filter)After refill check oil level. |
| Torque: | 25-33 ft/lbs (Oil Drain Plug) |
What kind of oil does a 2002 Hyundai Santa Fe use?
Engine Oil
| Viscosity: | 5W-30, 5W-40 (Below 35) 10W-30, 10W-40, 10W-50 (Above -23) 20W-40, 20W-50 (Above 0) |
|---|---|
| Capacity: | 4.8 quarts (with filter)After refill check oil level. |
| Torque: | 25-33 ft/lbs (Oil Drain Plug) |
What kind of oil does a Hyundai Santa Fe 2019 take?
As with most other consumer-grade vehicles, the 2019 Santa Fe uses parts and fluids that you can find just about everywhere. The next time you’re at the auto parts store, either pick up a quart of 5W-20 or 5W-30 oil; these are the recommended build for the Santa Fe, and also two of the most commonly available.
How do you change the oil in a Hyundai Santa Fe?
Just take off the 6 bolts that hold the plastic engine cover off and unscrew the plastic top off the oil filter canister (when you take the it off, watch because it will have oil up in it and when you tilt it, it will spill on the engine).
Where do you change the filter on a Hyundai Santa Fe?
They sell the crush washers also. Note that if you go to their site, they list the wrong filter for the Santa Fe (it may be the one for the 2.7L engine). You can go under Sonata instead to see the correct one. Replacing the oil and filter is easy because you get to the filter from on top of the engine.
How to change the oil on a Hyundai Elantra?
In this guide, you will find instructions on how to change the engine oil on Hyundai vehicles with a four-cylinder engine such as Santa Fe, Sonata, Accent, Elantra, Veloster, etc. The video clips and pictures in this guide are from a 2015 Hyundai Elantra. Follow these steps to change the engine oil on your Hyundai. Drive the car up on-ramps.
How much oil to put in Hyundai engine?
If your Hyundai requires 4.5 liters/quarts, start by adding 4 quarts. Wait a few minutes and check the engine oil level. Re-check engine oil level Lower your vehicle from the jack or your ramp. Next, start the engine and let it run for a minute. Turn off the engine and let the car sit for a few minutes.
Park your Hyundai Santa Fe on a level surface and put the gears in park. Raise the front end of the vehicle up on a jack stand using jacks and block the rear wheels. Crawl under the vehicle and locate the oil pan drain plug. Slide a drain pan under the plug and carefully remove the plug with a wrench.
How often do you change transmission fluid on a Hyundai Santa Fe?
The first and the most reliable method should be to check your Santa Fe owners’ manual. Under normal circumstances, Hyundai recommends changing your fluid after every 50,000 miles or a little over 40 months.
When to change the gasket on a Hyundai Santa Fe?
Although changing the gasket in Hyundai Santa Fe’s after 2000 is more complicated, dealing with a Santa Fe from 2000 and earlier is fairly straightforward. Park your Hyundai Santa Fe on a level surface and put the gears in park.
How long does it take to change oil on Hyundai Elantra?
If for any reason you don’t, return it within 3 days and exchange it for another new Hyundai. Get in. Get out. Get back to your life. Enjoy fast oil changes and more to help maintain your Hyundai.