What kind of engine stop does a 1987 Hino RB145 have?
Our 1987 RB145 has an engine stop system using a vacuum actuator which is controlled by a solenoid valve. The bus has always started easily, run well and give good fuel consumption with the one embarrassing and potentially dangerous limitation that at 2700-2800rpm under load, the engine would suddenly cut out.
Where can I get a Hino Truck Repair Manual?
This means more information for more accurate repairs. Hino Trucks dealers and body builders now have direct access to download 3D CAD models (.stp files) of all 2016MY and up conventional and COE chassis to be used for body design via a dedicated website www.hinocaddesign.com.
Where can I download Hino 2016 COE chassis?
Hino Trucks dealers and body builders now have direct access to download 3D CAD models (.stp files) of all 2016MY and up conventional and COE chassis to be used for body design via a dedicated website www.hinocaddesign.com. The site requires registration and approval from Hino Trucks prior to accessing any information.
Where is the TX valve on a Hino bus?
After having it rebuilt with all new seals it still leaked, indicating a blockage in the system which proved to be the Tx valve. Now the Tx valve is the original component around which Hino built the bus! It’s on the upper side of the LH end of the ‘hump’ aircon unit.
What are the parts of a Hino truck?
POWER STEERING GEAR SOX ASSEMBLIES AND REPAIR KITS… POWER STEERING OIL PUMP ASSEMBLIES — TIE ROD END ASSEMBLIES. DRAG LINK ASSEMBLIES UNIVERSAL JOINT KITS DRIVE SHAFT COMPONENT PARTS… KING PIN SETS AXLE SHAFTS LUG NUTS _ HUB BOLT KITS — WHEEL STUDS REAR WHEEL INNER CAP WHEELS _ VALVE STEMS FLYWHEEL ) CLUTCH.
Where is the valve on a Hino hump aircon unit?
It’s on the upper side of the LH end of the ‘hump’ aircon unit. The simple and lowest cost solution was to cut a hole in the roof (in the right place) to enable the valve to be changed.