What kind of engine does a Honda NX 250 have?
The NX250 featured the new MD21E engine which was a liquid-cooled, 249 cc, single-cylinder, four-valve, DOHC, four-stroke with an electric start. It had a bore and stroke of 70.0 mm × 64.8 mm (2.76 in × 2.55 in), 11 to 1 compression ratio, and a six-speed transmission.
How much oil does an XL 4 Fork need?
For xl-4 models onward (with abs) the righthand fork requires 538 cc while the lefthand fork requires 511 cc. So, if you still have the original springs mounted inside, you will indeed need a little more than a litre to completely refresh the oil.
How big is the dust seal on a Honda NX250?
• Be careful not to damage the piston sliding surfaces. (2> DUST SEALS SERVICE LIMIT: 26.89 mm (1,0587 in) Measure the caliper cylinder inside diameter. Page 229 HYDRAULIC BRAKE Install the pivot boot on the caliper bracket and make sure that the boot is seated in the groove properly. properly.
How to drain hydraulic fluid from Honda NX250?
HYDRAULIC BRAKE MASTER CYLINDER DISASSEMBLY Drain brake fluid from the hydraulic system (page 14-3). CAUTION * Avoid spilling fluid on painted, plastic, or rubber parts. Placea rag over these parts whenever the system is serviced. Remove the rear view mirror.
The NX250 featured the new MD21E engine which was a liquid-cooled, 249 cc, single-cylinder, four-valve, DOHC, four-stroke with an electric start. It had a bore and stroke of 70.0 mm × 64.8 mm (2.76 in × 2.55 in), 11 to 1 compression ratio, and a six-speed transmission.
HYDRAULIC BRAKE MASTER CYLINDER DISASSEMBLY Drain brake fluid from the hydraulic system (page 14-3). CAUTION * Avoid spilling fluid on painted, plastic, or rubber parts. Placea rag over these parts whenever the system is serviced. Remove the rear view mirror.
• Be careful not to damage the piston sliding surfaces. (2> DUST SEALS SERVICE LIMIT: 26.89 mm (1,0587 in) Measure the caliper cylinder inside diameter. Page 229 HYDRAULIC BRAKE Install the pivot boot on the caliper bracket and make sure that the boot is seated in the groove properly. properly.
Where can I find the Honda NX250 shop manual?
Page 219 HYDRAULIC BRAKE 35 N w f3.5 ko-m, 25 fl-Ui! 1 ,S ft-lb} 14-0… 14. HYDRAULIC BRAKE SERVICE INFORMATION BRAKE PAD/DISC MASTER CYLINDER BRAKE CALIPER BRAKE FLUID RE PLACEMENT/BLEEDING 14-3 SERVICE INFORMATION GENERAL The brake pads can be removed without disconnecting the hydraulic system.