What kind of axle does a jeep use?
The aluminum Dana 44 is a C-clip type axle and it doesn’t use standard Dana 44 components. This diff is internally similar to the Dana 44 rear-differential in the Dodge Viper, which has an IRS D44 setup. Chrysler 8.25 – 27 spline, 1.17″ diameter shafts, 8.25″ ring gear, 3″ axle tube – used 91-96
Which is better Dana 44 or Chevy 10 bolt?
Dana 44s vs. Chevy 10-Bolt Front Axles: Which Is Better? – Dirt Every Day Extra – YouTube Dana 44s vs. Chevy 10-Bolt Front Axles: Which Is Better? – Dirt Every Day Extra If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations.
What kind of axles does a Jeepster Commando have?
Jeepster Commando: Dana 44 rear axle on all Jeepster Commandos, 67-69 had tapered axle Dana 44 and the 70-71 had the flanged Dana 44 axles. YJ Wrangler: Some early YJs also had a Dana 44 in the rear, but this option was only available in Canada.
What does C stand for on a jeep axle?
The C does not stand for c-clip, it stands for custom. This means that it was shipped to Chrysler incomplete from Dana and then Chrysler finishes the build. Axle housing diameter = 2.625″
What kind of axles does a Jeep Wrangler use?
The Three Wrangler Dana Axles. The Dana portion is the nameplate of Dana Inc., who is the manufacturer of the Jeep axles. There have been a few different axles used in Wranglers over the years with the Dana 44 being the most popular.
How are axles measured on a Wrangler model 44?
The non-Rubicon model 44s are the same length. Axle shafts with a u-joint in the center are measured from the center of the u-joint. Measuring front the center to the end of the shaft will get you the inner and outer axle lengths. C-clip axle shafts and semi-float axle shafts are measured slightly differently than the full-float shafts.
What’s the difference between Dana and JK Rubicon axles?
JK Rubicon models have a thicker, slightly redesigned 44. This Rubicon axle is referred to as a Super Dana 44. Dana 44 – For TJs, the inner and outer axle has 30 splines. JK Rubicon model front axles have 30 inner splines and 32 outer splines.
What’s the difference between Dana 30 and Dana 44 axles?
Aside from the differential covers, the biggest difference between the axles is the size. The number in the name (Dana 30, Dana 44, etc.) is in reference to the sizes of the axle. Dana 30: This axle size is the most common and is usually found on Sport and Sahara models. They have a ring gear diameter of 7 & 1/8”.