What kind of actuator does a Jeep Grand Cherokee use?
We offer a full selection of genuine Jeep Grand Cherokee Blend Door Actuators, engineered specifically to restore factory performance. Please narrow the Air Blend Door Actuator results by selecting the vehicle.
How to replace a blend door actuator in a jeep?
Hold the actuator in place with your hand and see if its operator correctly by using Heat and AC. STEP NINE: Replace the F@ $%ING screws. STEP TEN: Grab a beer and give yourself a pat on the back!
What’s the problem with my Jeep GR Cherokee?
Wife’s 2011 Jeep GR Cherokee having issues with heating. Passenger side warms not to badly, Drivers side cool. . all the bolts out but its hung up somehow on the airbag unit, where am i going wrong?
Why is my AC not working on my Grand Cherokee?
(Playback ID: n9yfHbPSg17aR-tN) An error occurred while retrieving sharing information. Please try again later.
We offer a full selection of genuine Jeep Grand Cherokee Blend Door Actuators, engineered specifically to restore factory performance. Please narrow the Air Blend Door Actuator results by selecting the vehicle.
Where is the actuator on a 2009 Jeep Laredo?
If anyone needs to do this on a 2009 Grand Cherokee Laredo with the single A/C system (not two sided) here is what I found out in getting it done yesterday and today. 1) the actuator is on the driver side to the right of the steering column.
How to remove the blend door actuator on a jeep?
Remove the lower portion of the heater duct. You can now visually inspect the blend door actuator up against the center console, attached to the blend box, but the screws will seem impossible to remove! To get to those screws, you must remove the upper portion of the heater duct. It’s made as a clam shell so it comes apart in two pieces.
Where is the actuator on the driver side?
1) the actuator is on the driver side to the right of the steering column. 2) before you touch anything, disconnect the negative battery cable and wait 10 minutes for the airbag capacitor to discharge. 3) remove the knee bolster (or “hush panel”) by putting your fingers in the curved part that is just below the steering column and pulling down.
Why is my Jeep Grand Cherokee blend door not working?
I have a problem with the blend door motor on the driver side in my Jeep Grand Cherokee 2014. The heating is working on high only and I can’t adjust the temperature. The Dealer calibrated the blend doors but the problem still came back. I think the blend door motor is not regulating across the temperature range.
What’s the difference between old and new blend door motor?
The old blend door motor had a black shaft where the gear is mounted and the new motor, which the dealer installed has a white shaft, where the gear is mounted. Can anybody help me in solving the issue? I have a problem with the blend door motor on the driver side in my Jeep Grand Cherokee 2014.
Do you need to calibrate your blend door actuator?
Your blend doors should be calibrated, especially after having work done on them. I find it hard to believe that a place that does the work on blend doors doesn’t have a scanner capable of calibrating them. I have an Autel MS906BT and have had to do this calibration on all three of my DCX/FCA vehicles.
How to diagnose and replace Jeep Grand Cherokee blend doors?
This video shows you how to Diagnose and Replace the Blend Doors in a 1999-2004 Jeep Grand Cherokee. Make sure that your specify if your vehicle has two heat zones or just one. New part we installed is designed for one heat zone. This is why it was not necessary to reinstall the blend door partition.
The old blend door motor had a black shaft where the gear is mounted and the new motor, which the dealer installed has a white shaft, where the gear is mounted. Can anybody help me in solving the issue? I have a problem with the blend door motor on the driver side in my Jeep Grand Cherokee 2014.
Your blend doors should be calibrated, especially after having work done on them. I find it hard to believe that a place that does the work on blend doors doesn’t have a scanner capable of calibrating them. I have an Autel MS906BT and have had to do this calibration on all three of my DCX/FCA vehicles.
Is there a fix for my Jeep Grand Cherokee?
To avoid this, cancel and sign in to YouTube on your computer. Follow me for videos on my 2017 Ford Focus RS & the 2020 Hyundai Veloster N (Previously: 2017 Dodge Challenger RT, 2005 Jeep Grand Cherokee WK lifted, 2010 Jeep Wrangler Unlimited Sport (JKU)), and daily life driving it and living with it.
Remove the lower portion of the heater duct. You can now visually inspect the blend door actuator up against the center console, attached to the blend box, but the screws will seem impossible to remove! To get to those screws, you must remove the upper portion of the heater duct. It’s made as a clam shell so it comes apart in two pieces.
If your heater control does not look like the one in the 4th picture above, this kit will not work for you. This system can exhibit more than 1 type of failure, this kit is designed to repair the most expensive of those failures – the blend door drive breaking off of the door itself.
If anyone needs to do this on a 2009 Grand Cherokee Laredo with the single A/C system (not two sided) here is what I found out in getting it done yesterday and today. 1) the actuator is on the driver side to the right of the steering column.
How to repair a blend door on a jeep?
Remove the actuator by pulling it straight out of the heater box, allowing it to hang from the wiring. The black actuator to blend door drive shaft should stay connected to the actuator, but if it did not remove it from the heater box and install it on the actuator (it can only install one way). Make sure this shaft is not broken.
Do you need a new blend door actuator?
If the black actuator to blend door drive shaft itself is broken, you will need a new actuator to blend door shaft, which has been discontinued by Jeep but is also available from us on the product page. We also do stock OEM blend door actuators.
Where can I buy a Jeep Grand Cherokee a / C heater?
Shop AutoZone for Jeep Grand Cherokee A/C Heater Blend Door Actuator. 10% OFF $75. Use Code: DIYSAVE10 Online Ship-to-Home Orders Only