What is wrong when your car has no power?
Car Has No Power When Pulling Away Again, there could be several different reasons, including the following: Mechanical problems: Low compression, clogged fuel filter, dirty air filter or clogged exhaust manifold. Malfunction of actuators: Bad injectors, bad fuel pump, bad spark plugs.
Where is the key hole on a Porsche?
If your Porsche has a visible key hole, simple insert the mechanical key and turn. If a key hole is not visible, look for a separation in the driver’s door handle towards the back. It marks a cover hiding the keyhole. Then look beneath the cover for a slot.
How do you turn a Porsche dead FOB?
Turning over the fob, look for a small slide lever near the key ring side. Slide it to the side with a fingernail and pry the lever towards the top at the same time. Work the key out of the fob. Now, check if a key hole is immediately visible or not… If your Porsche has a visible key hole, simple insert the mechanical key and turn.
What to do if your Porsche 911 engine wont start?
2. Remove the air cleaner cover and air filter, and spray some fuel into the intake. You will have to hold open the little “door” inside there with something. If it starts briefy then dies you probably have a fuel problem. 3. You can jumper a hot wire to the fuel pump and listen to it whir to prove that it’s working.
Where are the DME fuses on a Porsche 911?
All DME-related fuses are up front, but there are three fuses under the plastic cover at the left rear side of the engine compartment. 9. If you have one available, swap in a known working DME computer from a 911 friend. Be careful that you have the right production year and part number because there are differences in the pin mappings.
What should I do if my Porsche 997 key fob is not working?
Remove the key and press one or more of the remote buttons to ensure it’s working properly. (Related Article: Porsche 997: How to Replace Key Fob Battery – Rennlist.com) Figure 1. Check and replace the key fob battery if necessary. It may need to be re-synced to work properly.
2. Remove the air cleaner cover and air filter, and spray some fuel into the intake. You will have to hold open the little “door” inside there with something. If it starts briefy then dies you probably have a fuel problem. 3. You can jumper a hot wire to the fuel pump and listen to it whir to prove that it’s working.
How do you change the FOB on a Porsche?
If you need to do it yourself, start by placing the key in the ignition and moving it to the second position. From there, you’ll need to hold down the unlock button on the key until a red light begins to flash on the dash. Figure 3. Replace the key fob, then re-sync with the car. The fob will need to be replaced.
Why does my car keep running after I remove the key?
Here are the most common problems that cause the engine to keep running even after removing the key from the ignition or press the STOP button. The ignition module may fail, or if your car is equipped with an Engine Push to the Start button, the Keyless module could be the culprit.