What is the short service connector on a Honda?
The tool, part number 070PZ-ZY30100, is an electrical connector with a built in jumper wire. The tool connects to the Data Link Connector (DLC), and jumps two wires of the DLC to create an input to the ECM. While the wires can be jumped manually without the tool, the tool insures the correct wires are jumped.
What kind of wire does a Honda DLC use?
The DLC wires that are jumped by the tool vary in color from model to model- the CBR250R uses blue and green wires, but the VFR1200F uses brown and green wires. Make sure to have the service manual to correctly identify the wires of the DLC if attempting a jump of the DLC without the tool. Locate the red 4-pin DLC to use the SCS service connector.
What are the warning lights on a Honda?
The following are warning lights and indicators found in vehicles built by Honda. Click a link to learn more about each one. They are roughly ordered by importance, which tends to be by color (red, amber, yellow, orange, green, blue, gray).
How do you short a service connector on a Honda ECM?
Start by turning the ignition switch to the OFF position. Remove the dummy connector from the DLC. Short the indicated wires of the DLC with the SCS service connector. Turn the ignition switch ON and the engine stop switch to RUN. If the ECM has any DTC in its memory, the MIL will start blinking. The MIL blinks indicate the DTC.
The tool, part number 070PZ-ZY30100, is an electrical connector with a built in jumper wire. The tool connects to the Data Link Connector (DLC), and jumps two wires of the DLC to create an input to the ECM. While the wires can be jumped manually without the tool, the tool insures the correct wires are jumped.
How do you short the DLC terminals on a Honda?
Turn the ignition switch ON and the engine stop switch to RUN. Remove the special tool to disconnect the jump. The MIL will light for approximately 5 seconds. While the MIL lights, short the DLC terminals again with a special tool. The self-diagnostic memory is erased if the MIL goes off and then starts blinking.
Start by turning the ignition switch to the OFF position. Remove the dummy connector from the DLC. Short the indicated wires of the DLC with the SCS service connector. Turn the ignition switch ON and the engine stop switch to RUN. If the ECM has any DTC in its memory, the MIL will start blinking. The MIL blinks indicate the DTC.
The following are warning lights and indicators found in vehicles built by Honda. Click a link to learn more about each one. They are roughly ordered by importance, which tends to be by color (red, amber, yellow, orange, green, blue, gray).