What is the idle control code on a Nissan Murano?
This Nissan Murano had a code P0507 after performing other repairs and cleaning out the throttle body.
What is the idle speed relearn procedure on a Nissan?
ECM sets a P0507 trouble code, requiring an idle speed relearn procedure. Late model Nissan engines are equipped with an electronic throttle body. The ECM commands a throttle plate opening to maintain the lowest possible idle speed based on engine temperature. This is called the target engine speed.
When to release the accelerator on a Nissan Murano?
Fully release the accelerator pedal within 3 seconds after the MIL turned ON. Start engine and let it idle. Wait 20 seconds. Rev up the engine two or three times and make sure that idle speed and ignition timing are within the specifications.
How to idle and relearn Nissan p0507?
Wait EXACTLY 7 seconds and press the pedal and keep it depressed for about 10 seconds until the check engine light starts blinking. If the check engine doesn’t blink after 20 seconds, turn the key to the OFF position. Wait at least 10 seconds and begin the procedure from the start.
When to do idle air volume learning in Nissan Murano?
Each time electric throttle control actuator or ECM is replaced. Idle speed or ignition timing is out of specification. Before performing Idle Air Volume Learning, make sure that all of the following conditions are satisfied.
What is the idle relearn procedure for a Nissan?
Battery voltage must be more than 12.9 V engine running at idle Electric load switches OFF. That means no A/C, headlamp, rear window defogger If you have daytime running lights (DRL) do this procedure to shut them off: BEFORE starting the engine: Apply the parking brake, or set the lighting switch to the 1st position.
Fully release the accelerator pedal within 3 seconds after the MIL turned ON. Start engine and let it idle. Wait 20 seconds. Rev up the engine two or three times and make sure that idle speed and ignition timing are within the specifications.
Do you need to do a Nissan throttle body relearn?
If you own a 2002-2011 Nissan Altima and clean or replace the throttle body or replace the ECU, you must do a Nissan Throttle Body Relearn Procedure to get a proper idle speed. Nissan calls this an Idle Air Volume Learning Procedure You can also perform this procedure if you feel the idle speed it out of spec.