What is the first step in installing the clutch disc?
The first step in installing our clutch is to attach the 7–inch button flywheel to the flexplate on the back of the crankshaft and torque it into place. Next, the clutch assembly is put together. This particular clutch assembly is a 7–inch, three-disc pac Pro Series set from Quarter Master.
How do I change the clutch on my car?
After securing all the bolts on the engine mount and around the transaxle, remove jack stands and gently release the jack to lower the front end of your vehicle. To make sure that your new clutch is working well, try to drive your car around the block a couple of times.
How do you replace a clutch master cylinder?
Step 1: Install entire system. Very carefully, install the entire system (clutch master cylinder, hydraulic line, and slave cylinder) down through the engine compartment. Warning: Do not bend the hydraulic line as it will break. Step 2: Install the slave cylinder.
How do you replace the transaxle on a clutch?
To replace the transaxle, align the transaxle with the clutch disc splined hole. Gently move the transaxle forward until the input shaft glides into the clutch disc’s splined hole.
When do you need to replace a clutch pedal?
The flywheel below is what a the typical wear pattern looks like during a clutch replacement and can be re-machined which must be done anytime you are servicing the clutch. If this step is skipped when the new clutch is installed you will have a good chance that it will chatter when the clutch pedal is released and the job will need to be redone.
To replace the transaxle, align the transaxle with the clutch disc splined hole. Gently move the transaxle forward until the input shaft glides into the clutch disc’s splined hole.
When do you need to replace the clutch assembly?
When these fingers are out or with no pressure on them the clutch is engaged. When replacing the clutch assembly it is highly advised to replace the throwout bearing because it has a high failure rate. Some throwout bearings are attached to the clutch slave cylinder which should be replaced as a unit.
How do you replace a clutch disc on a car?
With the clutch disc loose position and install the clutch alignment tool into the clutch disc and pilot bearing. Slightly tighten the bolts further to hold the disc in place and move the tool in a circular motion.
How do you replace the clutch on a Honda Civic?
The rear transmission mount is held in by a 17mm bolt and the starter has two 14mm bolts, a wire clip, and a 12mm cable nut. The slave cylinder assembly is held in place by two 12mm bolts. Figure 11. Remove bolts for rear torsion mount. Figure 12. Remove the starter bolts. Figure 13. Remove the clutch line bracket. Figure 14.