What is my Jeep axle ratio?
So an easy way to determine your actual gear ratio is to check the tag attached to the differential cover by the cover bolts. On the tag there should be some numbering such as 3.54 or 3.73, either of those numbers will give you the stock axle ratio.
How do I decode my jeep VIN number?
How to Decode a Jeep VIN?
- 1 – Country (USA)
- C – Manufacturer (Chrysler)
- 4 – Vehicle Type (Passenger Car)
- NJCBA – Description (4WD/4DR/SUV/Jeep Compass)
- 9 – Check Digit.
- G – Model Year (2016)
- D – Assembly Plant (Belvidere, Illinois)
- 681479 – Production Sequence Number.
How big are the axles on a Jeep Wrangler?
Rubicon’s are equipped with a new design Dana 44 in the front and rear. Revolution Gear & Axle offers Ring and Pinion Gear Sets in several different ratios for the following axle models, across all years of the Jeep Wrangler. These axles have a 7.2” Ring Gear Diameter.
What’s the gear ratio for a jeep TJ?
You can get away with a lower gear ratio and still crawl slower than your friends with 2.71:1. On the other side of the same equation you can gear the same as your friends without Rubicon’s and crawl even slower!
What’s the crawl ratio on a jeep TJ?
Also keep in mind that this is a general chart. It does not take into account what transfer case you have.. If your TJ is not a Rubicon you will have a NV231 t-case and 2.71:1 crawl ratio. If you have a Rubicon you have a NV241 t-case and a 4:1 crawl ratio. This has a very big effect when you are wheeling in 4-low!
What kind of differential does a jeep TJ have?
Jeep introduced the inaugural Rubicon trim level on the 2003 TJ, geared toward off-roaders. Rubicon’s came standard with locking front and rear differentials. TJs come with a Dana 30 or a Dana 44 in the front and either a Dana 35 or a Dana 44 in the rear. Typically the Sport and Sahara models include the Dana 30-Front/Dana 35-Rear.
Rubicon’s are equipped with a new design Dana 44 in the front and rear. Revolution Gear & Axle offers Ring and Pinion Gear Sets in several different ratios for the following axle models, across all years of the Jeep Wrangler. These axles have a 7.2” Ring Gear Diameter.
Jeep introduced the inaugural Rubicon trim level on the 2003 TJ, geared toward off-roaders. Rubicon’s came standard with locking front and rear differentials. TJs come with a Dana 30 or a Dana 44 in the front and either a Dana 35 or a Dana 44 in the rear. Typically the Sport and Sahara models include the Dana 30-Front/Dana 35-Rear.
How do you find the gear ratio on a Jeep Wrangler?
If you remove the diff cover and count the teeth on the ring gear and divide it by the number of teeth on the pinion gear that will give you your gear ratio. There is also another way of doing it by counting rotations of the drive shaft and tire but not to sure how to do that and not sure if it works on the front too. Thanks for the replies.
What kind of axle does a Wrangler Rubicon have?
Rubicon models come standard with a 4.10 rear gear ratio and also use a Dana 44 axle in the front with either a 3.73 or 4.10 gear ratio. The width of the axle shafts is 1.31 inches.