What is Harley ECM?
The electronic control module (ECM) or engine control unit (ECU) is responsible for creating a well-balanced air-fuel ratio. Harley fans choose to tweak stock ECM components in the hopes of creating the ultimate riding experience.
What is a flasher relay motorcycle?
Overview. Electronic LED Flasher Relays for Motorcycle have no minimum load-12VDC. Eliminates the need for load resistors, turn signals will flash at normal rate with or without LED bulbs. Price for each. Use the Flasher Selection Guide to determine the correct Flasher Relay for your vehicle.
Why is the blinker on my Harley Davidson not working?
If only one light (or one side) isn’t working, check the power to the bulb plug-in connections. With a voltmeter or test light, check the terminals for power. Check the battery for a full charge. Figure 1. Multimeter. Also consider what kind of work was recently done on the bike that might have affected the blinker system.
Can a broken turn signal on a Harley Davidson be fixed?
This article applies to the Harley Davidson Touring. A busted or erratic turn signal repair can be a drag to fix, especially on the road. It’s not a showstopper because you can still ride. But turn signals are an essential part of bike safety. Hand signals are fine during the day, yet are hard to see at night.
Where is the bank angle sensor on a Harley Davidson?
On some bikes it’s called a Bank Angle Sensor (BAS) and is located in the Turn Signal Security Module (TSM or TSSM). Check and clean your speed sensor. It may seem irrelevant but the TSSM serves many functions. Timing for turn signals is picked up by the speed sensor to control the time out distance/time.
Why is the left side of the turn signal not working?
This time, though, the left or right side of the signals doesn’t work. You may see the dash indicator lamps illuminating brightly, but the turn lights won’t flash. You may be dealing with bad bulbs or a fault between that side of the circuit and the turn signal switch itself.
If only one light (or one side) isn’t working, check the power to the bulb plug-in connections. With a voltmeter or test light, check the terminals for power. Check the battery for a full charge. Figure 1. Multimeter. Also consider what kind of work was recently done on the bike that might have affected the blinker system.
Why are the turn signals on my Harley Davidson not working?
I’m not getting any power to the right side turn signals, the green arrow on the dash don’t light up on right, and turn signals are very dim and slow on left side. Wiring seems to check out, fuses ok.
On some bikes it’s called a Bank Angle Sensor (BAS) and is located in the Turn Signal Security Module (TSM or TSSM). Check and clean your speed sensor. It may seem irrelevant but the TSSM serves many functions. Timing for turn signals is picked up by the speed sensor to control the time out distance/time.
Why is my turn signal not flashing on my Fatboy?
Had the same problem on a 99 Fatboy changed the ignition switch and problem was solved Have a 97 FXDWG. Installed a badlander load equalizer 17 years ago for run and brake lights on the rear. If the bike is not moving the right turn signal functions correctly.