What is EPDM pipe boot?
The premolded EPDM Pipe Boot is used to seal pipe penetrations. This pipe boot fits pipe penetrations between one to six inches. The stainless steel clamp is used to secure the top of the boot to the pipe.
Can you stretch EPDM?
EPDM rubber roofs offer many advantages, including: A life expectancy of approximately 50 years, due to its ability to stretch up to 300% before breaking.
What is a pipe flashing?
Pipe flashing, sometimes referred to as a roof boot, is manufactured to seal tightly around small ventilation pipes, plumbing, and other vents and equipment that protrude from the roof of a home or commercial building. The base is typically a flexible metal so that it is compatible with virtually any roofing material.
What is a roofing boot?
A roof boot is a preformed flashing for waterproofing pipe penetrations of a roof, similar to plumbing vent pipes and electrical service mast pipes. Pipe vents that run up from your kitchen and bathrooms out through your roof are covered by roof boots.
At what temperature does EPDM melt?
Ethylene-Propylene-Diene-Rubber-Mixture (EPDM) The melting above the glass transition (peak temperature at 31.4°C) is typical for the behavior of a sequence-type EPDM. The further endothermal effects (at 98.6°C and 110°C) are due to the evaporation of processing agents.
What kind of flashing does JM EPDM use?
JM EPDM Peel & Stick Flashing is a 6″, 9″, and 12″ (30.48 cm) wide, uncured EPDM (ethylene propylene diene monomer) sheet with a diamond texture on the top side with a release liner and a factory laminated, self-adhering EPDM/butyl tape.
How big are EPDM Peel and stick pipe boots?
JM EPDM Peel & Stick Pipe Boots are formulated to provide high initial strength in both peel and shear at typical rooftop temperatures. One-piece, prefabricated units with a factory-applied pressure sensitive tape on the bottom of the base flange. 2 1/2″ (6.4 cm) wide base flange.
How big is EPDM tape for Curb flashing?
60 mil thick, EPDM with a release liner and a 3″ or 6″ factory laminated, self-adhering EPDM tape. JM EPDM Pre-Taped Curb Flashing is produced with 60 mil (1.52 mm) thick, EPDM with a release liner and a 3″ or 6″ factory laminated, self-adhering EPDM tape to efficiently flash curbs with a consistent, clean appearance.
Do you need Carlisle Syntec for EPDM installation?
Installation is important when it comes to putting a single-ply roofing system on a building. There are over 150 variations of details available from Carlisle SynTec for EPDM roofing systems. Videos have been put together for many of these details, and can be found below.