What is CANbus error free LED?
CAN-bus Error Free LED bulbs are LED bulbs that have resistors that are internally/externally attached. The resistor’s job is to mimic the power draw of the stock incandescent bulbs to trick the computer to think that the bulbs are drawing the same rate of power so the vehicle does not throw any error messages.
Why is one side of my HID light not working?
Only one side is working on my HID kit or LED kit. If one side sometimes doesn’t turn on it could be caused by a bad bulb, HID ballast, LED driver or wiring. To help identify which component is defective follow these steps. Swap the ignitors to opposing sides (not applicable for LED kits). If the problem is reversed, you might have a bad ignitor.
Why does one side of my LED light not turn on?
If one side sometimes doesn’t turn on it could be caused by a bad bulb, HID ballast, LED driver or wiring. To help identify which component is defective follow these steps. Swap the ignitors to opposing sides (not applicable for LED kits). If the problem is reversed, you might have a bad ignitor.
What to do if your LED light is not working?
If you are having issues getting anything to work in your LED installation or your lighting is inconsistent go over this trouble shooting guide for some pointers on resolving your issue. If you are sure that your wiring is correct read our Multimeter troubleshooting guide on tips for testing the input and output of your LED Power Supply. 1.)
Why are my spotlights not working with led?
Now that the low beam filament is gone and replaced with LED, the spotlights do not work. In order to get a reliable trigger from a negatively switched wiring system, one must take two wires from the headlight, one from the common supply for low and high beam and one from the high beam terminal that will be grounded via the high beam dip switch.
Only one side is working on my HID kit or LED kit. If one side sometimes doesn’t turn on it could be caused by a bad bulb, HID ballast, LED driver or wiring. To help identify which component is defective follow these steps. Swap the ignitors to opposing sides (not applicable for LED kits). If the problem is reversed, you might have a bad ignitor.
What to do if your right side light is not working?
Since the right side is not working, you will want to test the pins of the connector for right turn and brake. If looking at the face of the connector, it is the pin in the 3 oclock position. If you are getting the proper signal at the connector, you know that the problem is on the trailer side.
If one side sometimes doesn’t turn on it could be caused by a bad bulb, HID ballast, LED driver or wiring. To help identify which component is defective follow these steps. Swap the ignitors to opposing sides (not applicable for LED kits). If the problem is reversed, you might have a bad ignitor.
If you are having issues getting anything to work in your LED installation or your lighting is inconsistent go over this trouble shooting guide for some pointers on resolving your issue. If you are sure that your wiring is correct read our Multimeter troubleshooting guide on tips for testing the input and output of your LED Power Supply. 1.)