What is a distributor pickup coil?
Electronic ignition pickups are a component found on traditional electronic distributor ignition systems. The pickup coil monitors the rotation of the distributor and triggers the ignition system at the optimal moment to produce the best timed spark for best engine performance.
How do you replace an ignition pickup coil?
Step 1: Disconnect the battery: Remove the negative terminal on the battery. Step 2: Remove the distributor cap and rotor. Step 3: Remove the ignition pickup coil: Disconnect the electrical wires to the pickup. Step 4: Replace the pickup coil: Install the new pickup coil, making sure the wire connectors and mounting screws are properly tightened.
How do you change a spark plug pickup?
Connect the spark plug pickup to the #1 cylinder wire. Start the engine and shine the timing light on the ignition marks. One mark will be stationary on the engine. The other will rotate with the engine. If the marks do not line up, rotate the distributor slightly until they do.
Where are the coils on an ignition coil?
They can be located on the face of the pickup coil or on the outside of the distributor. Step 4: Replace the pickup coil: Install the new pickup coil, making sure the wire connectors and mounting screws are properly tightened. Reinstall the ignition rotor, distributor cap, and plug/coil wires. Note: Follow steps 1-3 from Method 1 first.
How do you replace the distributor on a Chevy pickup?
In some vehicles, the pickup can be replaced while the distributor is left in place. In others, it may be easier to remove the distributor. This method involves leaving the distributor in place. Step 1: Disconnect the battery: Remove the negative terminal on the battery.
When to take spark plug off Jeep distributor?
After the distributor is in and wired up, your Jeep should fire up. If it doesn’t fire up, take a wire off, put a spark plug on the wire, hold the plug to ground and get someone to crank the engine so you can verify there is spark. If you don’t have spark, something is wrong with the wiring or the distributor.
How do you replace a HEI distributor on a jeep?
Get the #1 piston to the top with the starter or by turning the engine over with a wrench. Remove the distributor and get the rotor pointed to #1 wire on the distributor cap. Replace the #1 spark plug and 12v lead to the distributor. If it backfires, it may be 180 degrees off.
How to remove ignition coil from Willys Jeep?
How to remove the ignition coil from your Willys Jeep – Part of an ongoing “Jeep” disassembly and restoration series sponsored by Kaiser Willys. To watch other videos on the disassembly of your Willys Jeep Vehicle refer to The Build Your Willys series on YouTube.
Step 1: Disconnect the battery: Remove the negative terminal on the battery. Step 2: Remove the distributor cap and rotor. Step 3: Remove the ignition pickup coil: Disconnect the electrical wires to the pickup. Step 4: Replace the pickup coil: Install the new pickup coil, making sure the wire connectors and mounting screws are properly tightened.