What is a AC control head?
It is the physical switch that allows the user to turn on and change the settings of the AC system from inside of the vehicle. It is usually a custom panel with knobs and buttons that allow the user to control the functions of the AC system, such as setting, temperature, and intensity of the fans.
How do I reset my Nissan Pathfinder radio?
To reset the Nissan Pathfinder radio you will need to hold down the power button on the dash for 10 seconds.
How do I unlock my Nissan radio code?
Turn on the audio unit and enter the code 0000 three times in a row. The radio gets locked for sixty minutes, during which time it displays the serial number on the screen.
How do you reset a Nissan head unit?
Press the power button of Your radio once. It should come on and stay on. Press the power button again, but hold it down until the radio goes off on its own and comes back on. This process should trigger a reset of the radio.
What to do if your climate control is not working?
Make sure to check all fuses, some are not labeled as such, but work in conjunction. If you have total loss of power to the unit, why not test the ground pin on the harness attached to the climate control with an ohmmeter.
Why are the radio and AC control lights not working?
A bit of time (maybe 90 minutes removal, soldering and re-install) and a bit of solder added to a series of resistors on the circuit board and her radio display lights up again. Found the problem. The #4 fuse under the hood, labelled “small lights”.
Why is the ground pin on my climate control not working?
If you have total loss of power to the unit, why not test the ground pin on the harness attached to the climate control with an ohmmeter. Im not 100% for sure on the ISX50, but I’m willing to bet the ground wire is a white w/black stripe and is not switched to ground.
What kind of wire is the climate control?
Terminal 16 is a purple / orange wire and must have 12 volts when the ignition switch is on. To check the ground wire, move the test light’s ground clip to a positive source. The easiest to find is the battery’s positive cable. Now, the test light will light up when you probe a good ground. Terminal 3 is a black wire.