What happens when you change your oil filter?
Changing your oil filter ( and oil, of course) is the cornerstone of responsible engine maintenance. But what happens when you go to do the thing and your oil filter is uncooperative? If you know how to remove a stuck oil filter you can get back to taking care of your car to keep it running smoothly.
How do you change the oil in a Chevy Silverado?
Turn ignition switch to ON position with engine off. Press the MODE button until the DIC reads “Oil Life Left/Hold Set To Reset”. Press and hold the SET button until the display reads “100 percent”. You will hear 3 chimes and the “Change Engine Oil Soon” message will go off.
What’s the repair manual for a Holden Colorado?
Motor Era offers service repair manuals for your Holden Colorado – DOWNLOAD your manual now! Holden Colorado service repair manuals
How to reset the Colorado Oil Change light?
Chevrolet Colorado Oil Change Light Reset Procedures: Turn ignition switch to ON position with engine off Fully depress and release the accelerator pedal 3 times within 5 seconds of turning key Change Oil lamp will flash for 2-10 seconds while it resets Once it stops flashing, the maintenance light reset is complete Turn key to OFF position…
How do you change the oil filter on a Chevy Colorado?
Unscrew it with the 14 mm wrench and allow all the oil to drain into the oil drain pan. Screw the oil plug back in tightly. Slide over to the front of the engine block on the passenger side of your Chevy Colorado. Unscrew the oil filter counterclockwise.
How to replace fuel filter on Holden Colorado?
Instructions on replacing the fuel filter on a Holden Colorado 3 litre diesel . I purchase filters from brettstruck.com.au . Part number for this filter is FE 0025 . The video contains visual instructions, not actual removal of filter. Loading…
How to turn off change engine oil and filter light on?
Please try again later. Holden captiva change oil indicator light turn off procedure. Remember when doing this procedure only do this if you are happy you don’t want to see the change oil reminder light on the dash every time you start your car.
How can I change the oil filter on my Duramax?
The easiest way to check that is to unplug the wires while the truck is running and see if it kills the engine, if it doesen’t unplug the other one on the same side of the valve cover. If both of these don’t cause any change then you have a bigger problem, the IDM (Injector drive module).