What happens when the TPS goes bad on a Polaris Ranger?
If the TPS goes bad it can make the Ranger run erratically, or cause a hesitation at certain rpms. The only way to test the TPS is to use the tool Polaris designed to test it, or backprobe the yellow wire at the connector with a mutimeter and watch the voltage as you run up the throttle.
What’s the idle speed on a Polaris Ranger?
I think Polaris spec’s the idle at 1250…..but mine idles around 1075 without any issues. In the service manual for 2009 700 XP, it says Engine Idle Speed is 1150 ± 100 RPM. Hope this helps a lil! In the service manual for 2009 700 XP, it says Engine Idle Speed is 1150 ± 100 RPM.
Why is my Polaris Ranger Club not running?
Most of the time when there is an issue with the TBap it is due to broken/bare wires, or occasionally dirt on the Tbap. When there is a problem with the Tbap the ECU is programed to make the machine run rich, but for some reason the machine will display a few different symptoms.
What’s the idle speed on a Polaris 700 XP?
In the service manual for 2009 700 XP, it says Engine Idle Speed is 1150 ± 100 RPM. Hope this helps a lil! In the service manual for 2009 700 XP, it says Engine Idle Speed is 1150 ± 100 RPM. Hope this helps a lil!
I think Polaris spec’s the idle at 1250…..but mine idles around 1075 without any issues. In the service manual for 2009 700 XP, it says Engine Idle Speed is 1150 ± 100 RPM. Hope this helps a lil! In the service manual for 2009 700 XP, it says Engine Idle Speed is 1150 ± 100 RPM.
What to do when your Polaris Ranger loses power?
Discon the TBAP connection at the sensor and check the wiring by GENTLY pulling on each wire-if the wire insulation changes color slightly the wire inside is broken and there lies your problem.
In the service manual for 2009 700 XP, it says Engine Idle Speed is 1150 ± 100 RPM. Hope this helps a lil! In the service manual for 2009 700 XP, it says Engine Idle Speed is 1150 ± 100 RPM. Hope this helps a lil!
What was the first time my Polaris Ranger Club broke?
On my 05 the first time my wires broke it idled badly but ran fine at higher RPM. The second time it idled fine and would die when I hit the gas. There is no way to test the Tbap.