What happens when the fuel pump goes out on a Pontiac Sunfire?
There are physical signs that you can feel when your Sunfire’s fuel pump is going out. Before taking anything apart, check to see if your engine’s computer has any trouble codes saved in it. The engine may throw a P0087 trouble code. This trouble code detects that the fuel rail/system pressure is too low.
What are the symptoms of a bad fuel pump?
With that in mind, most of the symptoms of a bad fuel pump revolve around the vehicle stalling out or not running at all. In modern fuel injected vehicles, the fuel pump sits right in the fuel tank and “pushes” the gasoline to the fuel rail (s).
Why is the fuel pump in the fuel tank?
It is in the fuel tank because “pushing” fuel to the fuel rail is easier than “pulling” the fuel, which is what an inline pump would do. While being in the fuel tank makes the pump more reliable, it also makes it a lot more difficult to get to.
https://www.youtube.com/watch?v=q5spZDprsHU
Where is the fuel pump relay on a Pontiac Grand Am?
The fuel pump relay is #18 in the fuse box. Start with the car off, and have somebody else put the key in the cars ignition and attempt to start the car while you listen to the relay. If you can hear this relay make a “clicking” noise as the car attempts to start, then it is working properly.
What does a bad fuel pump sound like?
A priming fuel pump sounds like a high-pitched whine for a few seconds and can be heard with a sharp engine right after the ignition key is turned, but before the starter is engaged. The symptoms of a bad fuel pump match a lot of other common problems that can occur in the Pontiac Sunfire.
Why is my fuel pump reset button not working?
Anything from factory security system locking you out, bad fuse/relay, clogged fuel filter,faulty fuel pump, oil sending unit/crank sensor failure, clogged catalytic converter, failing electronic ignition, ECM/PCM,etc.,etc. As a first step best to see if there are any stored trouble codes that could point directly to the fault.
There are physical signs that you can feel when your Sunfire’s fuel pump is going out. Before taking anything apart, check to see if your engine’s computer has any trouble codes saved in it. The engine may throw a P0087 trouble code. This trouble code detects that the fuel rail/system pressure is too low.
A priming fuel pump sounds like a high-pitched whine for a few seconds and can be heard with a sharp engine right after the ignition key is turned, but before the starter is engaged. The symptoms of a bad fuel pump match a lot of other common problems that can occur in the Pontiac Sunfire.
It is in the fuel tank because “pushing” fuel to the fuel rail is easier than “pulling” the fuel, which is what an inline pump would do. While being in the fuel tank makes the pump more reliable, it also makes it a lot more difficult to get to.
Why does my fuel pump not start when I change it?
You always want to replace the fuel filter when replacing the fuel pump. This could cause the concern you are having. It may seem as you are getting enough fuel from the pressure regulator but if the pressure from the fuel tank is not correct, it will still not start. Another problem you could be having is spark.
Why does my Chevy Spark Plug not start?
Chevrolets have a common issue with fuel filters getting clogged. You always want to replace the fuel filter when replacing the fuel pump. This could cause the concern you are having. It may seem as you are getting enough fuel from the pressure regulator but if the pressure from the fuel tank is not correct, it will still not start.
Why does my Car Crank and not start?
There are many reasons for your car to crank and not start. Anything from factory security system locking you out, bad fuse/relay, clogged fuel filter,faulty fuel pump, oil sending unit/crank sensor failure, clogged catalytic converter, failing electronic ignition, ECM/PCM,etc.,etc.
How does the fuel pump work on a Pontiac Sunfire?
The fuel pump has a relay and fuse – when the key is turned on, the pump should run for approx 5 to 8 seconds then stop, when the key is turned to the ‘run/start’ position, the fuel pump will continue to run. 2 people found this helpful. I have a pontiac sunfire 1997 out of nowhere it wouldn’t start.
There are many reasons for your car to crank and not start. Anything from factory security system locking you out, bad fuse/relay, clogged fuel filter,faulty fuel pump, oil sending unit/crank sensor failure, clogged catalytic converter, failing electronic ignition, ECM/PCM,etc.,etc.
Anything from factory security system locking you out, bad fuse/relay, clogged fuel filter,faulty fuel pump, oil sending unit/crank sensor failure, clogged catalytic converter, failing electronic ignition, ECM/PCM,etc.,etc. As a first step best to see if there are any stored trouble codes that could point directly to the fault.
Does the crank position sensor control the fuel pump?
Fuel Pump / Crank Position Sensor. Does crank position sensor control fuel pump? no, the CKP sensor does not control the fuel pump – just tells (as well as cam sensor) when the fuel injectors need to inject fuel into the intake.
Where is the fuel pump on a Pontiac Grand Am?
Check in the engine compartment fuse box, it should be near the battery under the hood. The cover should be pretty easy to remove. The fuel pump should be connected through a fuse in slot 48. If that fuse looks good, then you may want to check the fuel pump relay (also inside the engine compartment fuse box).
Check in the engine compartment fuse box, it should be near the battery under the hood. The cover should be pretty easy to remove. The fuel pump should be connected through a fuse in slot 48. If that fuse looks good, then you may want to check the fuel pump relay (also inside the engine compartment fuse box).
Where does the fuel pump go in a car?
In modern fuel injected vehicles, the fuel pump sits right in the fuel tank and “pushes” the gasoline to the fuel rail (s). It is in the fuel tank because “pushing” fuel to the fuel rail is easier than “pulling” the fuel, which is what an inline pump would do.
The fuel pump relay is #18 in the fuse box. Start with the car off, and have somebody else put the key in the cars ignition and attempt to start the car while you listen to the relay. If you can hear this relay make a “clicking” noise as the car attempts to start, then it is working properly.
Where are the fuse panels on a Pontiac Sunfire?
In this article, you will find fuse box diagrams of Pontiac Sunfire 1995, 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004 and 2005, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay.
Why does my fuel pump not prime when I turn it on?
Pulled fuel pump relay and put in a jumper wire to run the fuel pump and it started. Put the fuel pump relay back in and it starts and drives, but the fuel pump still doesn’t prime when turning the key on. I’m afraid that after sitting overnight, it will once again refuse to start.
Why is the fuel pump relay not closing?
If jumping the fuel pump relay makes the pump run, and if the relay tests good. Then you need to determine why the ECM is not telling the relay to close. Start by testing continuity back to the ECM. Here is the electrical diagram for the 01 Tib Fuel Pump Relay
What are the symptoms of a bad fuel pump in a Pontiac Sunfire?
Here are the most common symptoms of a bad fuel pump in your Pontiac Sunfire: One of the most common signs that a fuel pump is going bad is a whining sound. The whining sound can indicate that the fuel pump is going out before there are any performance based issues. Keeping an open ear can save you from getting stuck somewhere with a bad fuel pump.
Why does my 2000 Sunfire engine keep sputtering?
Same problems with 2000 sunfire replaced all the usual suspects plugs wires,tps,coils,idle sensor turned out to be ignition control module was gone once i replaced the module check engine light went off the car worked fine ever since. 3 people found this helpful.
Why does my 1999 GTP engine keep sputtering?
My 1999 GTP experienced the sputtering problem at 28,000 miles and it was the result of a defective wiring harness. I assume this to be very unusual but it can be the cause. Best of luck. 30 people found this helpful.
Is the car engine still sputtering and shaking?
The same sputtering and shaking that you report. My engine had only 28,000 miles on it at that time and now has 122,518 miles and runs smoothly and produces a bunch of power. I still enjoy owning it. 31 people found this helpful.
Same problems with 2000 sunfire replaced all the usual suspects plugs wires,tps,coils,idle sensor turned out to be ignition control module was gone once i replaced the module check engine light went off the car worked fine ever since. 3 people found this helpful.
My 1999 GTP experienced the sputtering problem at 28,000 miles and it was the result of a defective wiring harness. I assume this to be very unusual but it can be the cause. Best of luck. 30 people found this helpful.
The same sputtering and shaking that you report. My engine had only 28,000 miles on it at that time and now has 122,518 miles and runs smoothly and produces a bunch of power. I still enjoy owning it. 31 people found this helpful.
Where to get help for a Pontiac problem?
10 people found this helpful. For all you PONTIAC folks,Google pontiac problems,you will be sent to a Grand Am site,heck im even on their.lots of great info on pontiacs.a lot of guys their really know their stuff about theses cars. 31 people found this helpful.
How to check fuel pressure on a Pontiac Grand?
Attach the vacuum hose to the port on the fuel pressure regulator. Plug in the electrical connection for the fuel pump near the fuel tank on 2.4-liter models. On 2.2-liter and V-6 models, replace the cap on the end of the fuel rail.
Where is the pressure regulator on a Pontiac Grand?
Disconnect the fuel return line from the pressure regulator, located at the end of the fuel rail using a wrench. Pull the vacuum hose from the port on the pressure regulator. Unscrew the fasteners attaching the fuel pressure regulator to the fuel rail using a Torx screwdriver. Pull the regulator from the fuel rail.
How do you relieve the fuel system pressure?
Relieve the fuel system pressure. On V-6 and 2.2-liter models, remove the port cap on the end of the fuel rail. Place a rag at the end of the rail and press the small port with a small flat-head screwdriver to release the pressure.
In modern fuel injected vehicles, the fuel pump sits right in the fuel tank and “pushes” the gasoline to the fuel rail (s). It is in the fuel tank because “pushing” fuel to the fuel rail is easier than “pulling” the fuel, which is what an inline pump would do.
How does an electric fuel pump work in a car?
An electric fuel pump is an essential component that can be found in your car. The fuel pump is used to make sure the gas travels from the fuel tank to the engine. The fuel must travel through a hose, also called the fuel line, and it is the job of the fuel pump to make sure the gas reaches the proper location.