What happens to the throttle cable in reverse?
That is what I thought but when watching the system at the motor I see the control cable moving the shifter into/out of gear, the throttle cable pushes back when pushing throttle forward giving it gas. But no throttle cable movement once it is in reverse.
How to adjust reverse throttle on a Johnson outboard?
Thanks. After trying several times to adjust the thumb-wheel on the control cable at the motor and moving the cable locking bracket at the binnacle I finally discover the fix. There is a second hole in the Binnacle lever the pin to connect the control cable to the lever can go in.
What happens when the throttle gets stuck in an open position?
When the throttle gets stuck in an open position than your vehicle will receive too much air and cause it to have a high or fluctuating idle. What are signs of a bad Throttle Position Sensor? Acceleration issues: A bad TPS may cause all sorts of power issues. Your engine may start up but it will have little to no power and it causes it to shut off.
What happens when I put the car in reverse?
Put the car in reverse holding the brake the car stalls, if I go into neutral or drive it works fine. If I put the car in reverse not holding the brake it shifts rough but doesn’t stall. I have not driven the car at speeds higher than 35mph, so not sure of the other gears.
That is what I thought but when watching the system at the motor I see the control cable moving the shifter into/out of gear, the throttle cable pushes back when pushing throttle forward giving it gas. But no throttle cable movement once it is in reverse.
Thanks. After trying several times to adjust the thumb-wheel on the control cable at the motor and moving the cable locking bracket at the binnacle I finally discover the fix. There is a second hole in the Binnacle lever the pin to connect the control cable to the lever can go in.
When the throttle gets stuck in an open position than your vehicle will receive too much air and cause it to have a high or fluctuating idle. What are signs of a bad Throttle Position Sensor? Acceleration issues: A bad TPS may cause all sorts of power issues. Your engine may start up but it will have little to no power and it causes it to shut off.
Is there a way to reset the throttle body?
This method is almost foolproof as long as all ECU control parameters are within their normal ranges. Resetting The Throttle Body Calibration (this step is conditional) A Rough Idle or a SES can sometimes be caused by a change in the throttle body position sensor calibration.