What happens if a sensor fails for second gear?
So, if a sensor fails for second gear, you will not be able to use that gear. Sender G509, a key sensor, can be found in the housing of gearbox input speed sender G182. It measures the temperature of the DSG oil at the outlet of the multi-plate clutches. It operates in a temperature range of –55 °C to +180 °C.
Do you need dipstick to check Mercedes transmission?
The car doesn’t come with a dipstick to check the transmission level but you can order one online for under $20. You will need Dipstick Tool for 722.6 722.9 Mercedes-Benz Transmission for measuring fluid level. Watch the video below to learn how to check the transmission fluid level on your Mercedes-Benz.
Why is my Mercedes-Benz transmission not shifting?
If cracks develop between the two chambers, coolant will mix with transmission oil and it will destroy the transmission. This has been a well-documented issue for Mercedes-Benz cars equipped with the Valeo radiators.
What causes the transmission to go into limp mode?
Top reasons causing Transmission To Go Into Limp Mode: 1 Mass Air Flow Sensor could also cause your transmission to go into limp mode. 2 Defective shift module, inside the car. 3 Bad Speed Sensor 4 Brake Light Switch 5 Defective transmission control module. 6 Old Battery
What should the temp of the coolant sensor be?
Check that the temperature value of the CTS is around 80-90c when the engine is hot. A lot of engine coolant temperature sensors have two wires and the sensor is controlled by Ohm. Get a wiring diagram and find out what ohms you should have at a specific temperature to check the function.
Can a car have more than one coolant sensor?
Some vehicles may have more than one temperature sensors, as sometimes different sensors are used to send the signals to the dashboard and the control unit of your engine system. This is optional and a manufacturer can use only one coolant temperature sensor to send the signals to both of these desired receivers.
Why does my car coolant sensor keep dropping?
If there is a leak in the engine bay and the oil enters the engine block, the coolant will get contaminated, causing a problem to the ECT sensor. The coolant system of the car does not need constant refilling. However, if the coolant level is dropping frequently, there might be a leak which should be fixed immediately.
What are the symptoms of transmission shift solenoid?
The most common symptom of a damaged transmission shift control or wirings is a warning light on your dashboard. This is often lightened up by a Check Engine Light or a Transmission warning light. If you see a warning light on your dashboard, read the trouble codes with an OBD2 Scanner and start your troubleshooting there.