What does the rear access open message mean?
What does the Rear Access Open message mean? The Rear Access Open message will appear on your driver information center (DIC) when the trunk is not properly closed. After you close the trunk, the alert will go away. The statements expressed above are only for informational purposes and should be independently verified.
Why is rear access open light on when door is open?
@louis1 there are some sensor in the latch assembly that could register your access as being open. It’s a pretty involved task so try to reset your computer first. Disconnect the battery cable and for a few minutes keep holding the battery cables together.
Is there a problem with shared access back-end?
If the user CAN create a test file, then the problem probably lies in the code of the front-end. Opening a linked table will always open the back-end for shared access if possible, no matter if the front-end is opened exclusively or not.
What to do if rear access light is not working?
Disconnect the battery cable and for a few minutes keep holding the battery cables together. I prefer to leave them disconnected overnight and reattach those later. this should force your computer to relearn. If that does not work your have to take a look at the latch assembly.
@louis1 there are some sensor in the latch assembly that could register your access as being open. It’s a pretty involved task so try to reset your computer first. Disconnect the battery cable and for a few minutes keep holding the battery cables together.
What should I do if my rear door is open?
Lid is closed firmely, optical sensor is on place and not damaged. I also measured pulses from that optocoupler with the Scope and could see signal surges from 0V to 3V when the rear lid pin goes into the sensor. Could you please help with that issue.
Disconnect the battery cable and for a few minutes keep holding the battery cables together. I prefer to leave them disconnected overnight and reattach those later. this should force your computer to relearn. If that does not work your have to take a look at the latch assembly.
What causes printer to stop working with rear door open?
Hi, my HP LaserJet Pro CP1025 printer stopped working with alarm Rear Door Open. Lid is closed firmely, optical sensor is on place and not damaged. I also measured pulses from that optocoupler with the Scope and could see signal surges from 0V to 3V when the rear lid pin goes into the sensor. Could you please help with that issue.