What does the P1506 code on an engine mean?
The P1506 code means that the engine idle is out of factory specification. Sometimes the Idle Air Control (IAC) may have carbon built up.
What causes a P1506 Ford to overspeed?
P1506 FORD Possible Causes 1 Faulty Idle Air Control (IAC) valve 2 IAC valve harness is open or shorted 3 IAC valve circuit poor electrical connection 4 Intake leaks 5 Stuck PCV Valve
What to do if your Ford P1506 wont start?
Disconnect the car battery, remove the valve, clean, re-install valve, and drive the vehicle for about 5 minutes with the headlights and A/C ON to get the idle relearned. Also, check for intake leaks or stuck PCV Valve. If the problem persistss, the IAC valve may need to be replaced. If playback doesn’t begin shortly, try restarting your device.
How much does it cost to diagnose P1506 Ford code?
The cost of diagnosing the P1506 FORD code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour. When is the P1506 FORD code detected?
What causes IAC system overspeed error P1506?
PS the error code has always been “p1506 IAC system overspeed error”. A vacuum leak will also cause the “overspeed” error code. The only thing the computer knows is that there’s too much air getting into the engine and it’s causing it to idle too fast.
The P1506 code means that the engine idle is out of factory specification. Sometimes the Idle Air Control (IAC) may have carbon built up.
The cost of diagnosing the P1506 FORD code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour. When is the P1506 FORD code detected?
P1506 FORD Possible Causes 1 Faulty Idle Air Control (IAC) valve 2 IAC valve harness is open or shorted 3 IAC valve circuit poor electrical connection 4 Intake leaks 5 Stuck PCV Valve
Disconnect the car battery, remove the valve, clean, re-install valve, and drive the vehicle for about 5 minutes with the headlights and A/C ON to get the idle relearned. Also, check for intake leaks or stuck PCV Valve. If the problem persistss, the IAC valve may need to be replaced. If playback doesn’t begin shortly, try restarting your device.
Which is the correct code for Mercury check engine light?
1 Refer to our Generic OBD II code list for definitions on all other Mercury diagnostic trouble codes. 2 Manufacturer Specific Codes 3 P1000 4 P1001 5 P1039 6 P1051 7 P1100 8 P1101 9 P1105 10 P1106
What does it mean when your check engine light goes out?
Drive the car for a while and see if the light goes out (note that it may take a couple of restarts of the engine to make the light go out). If your car’s Check Engine Light is on, it means that there’s a problem somewhere in your emissions system.
Where to find Mercury check engine light codes?
When retrieving Mercury check engine light codes with an OBD II scan tool, proceed as follows: 1. Connect scan tool to the 16-pin data link connector (DLC) located underneath the steering column. The connector may have a removable cover. 2. Turn the ignition on. 3.
When retrieving Mercury check engine light codes with an OBD II scan tool, proceed as follows: 1. Connect scan tool to the 16-pin data link connector (DLC) located underneath the steering column. The connector may have a removable cover. 2. Turn the ignition on. 3.