What does the code P1148 mean?
P1148 Meaning The Engine Control Module (ECM) performs ON/OFF duty control of the Air Fuel Ratio (A/F)/Heated Oxygen Sensor 1 heater corresponding to the engine operating condition to keep the temperature of Air Fuel Ratio (A/F)/Heated Oxygen Sensor 1 element at the specified range.
What does the ABS warning light on a Nissan mean?
ABS Warning Light: It indicates that your ABS fluid at a low level or possible problem in ABS system, however the ABS light turn on for about 2 seconds after starting engine and then go away, if it remains ON in a car dashboard then it indicate an issue with the ABS.
Where is the Diagnostic Code on Nissan overheat warning lamp?
Check that Overheat Warning Lamp is displaying Diagnostic Display Code. Connect memory clear connector 2400400Z09, or a suitable jumper wire to reset switch terminals. The reset switch is located behind the electrical unit board. Check that Overheat Warning Lamp and Buzzer display shows Diagnostic Display Code 0–1.
What should I do if my ABS sensor is not working?
If the POWER indicator does not illuminate, replace the battery in the ABS active wheel sensor tester before proceeding. d. Spin the wheel of the vehicle by hand and observe the red SENSOR indicator on the ABS active wheel sensor tester. The red SENSOR indicator should flash ON and OFF to indicate an output signal.
Where do I find the trouble code on my Nissan?
On all models, to erase DTCs using generic scan tool (GST), select mode 4. Place diagnostic switch in the Off position. Place ignition switch in the On position. Crank engine. Start and operate engine. The trouble codes will be displayed by the flashing Engine Control Lamp and the Overheat Warning Lamp and the Overheat Warning Buzzer.
If the POWER indicator does not illuminate, replace the battery in the ABS active wheel sensor tester before proceeding. d. Spin the wheel of the vehicle by hand and observe the red SENSOR indicator on the ABS active wheel sensor tester. The red SENSOR indicator should flash ON and OFF to indicate an output signal.
What is the OBD code for a Nissan check engine light?
Refer to our Generic OBD II code listfor definitions on all other Nissan diagnostic trouble codes. Manufacturer Specific Codes P1105MAP/BARO Pressure Switch Solenoid Valve P1110Intake Valve Timing Control Solenoid
How to test the ABS wheel speed sensor?
Connect the ABS active wheel sensor tester (J-45741) to wheel sensor using the appropriate adapter. c. Turn on the ABS active wheel sensor tester power switch. NOTE:The green POWER indicator should illuminate. If the POWER indicator does not illuminate, replace the battery in the ABS active wheel sensor tester before proceeding. d.
How long does it take to read NISSAN OBDII code?
The ‘zero’ is indicated by the number of ten flashes. The length of time the 1,000th-digit numeral flashes on and off is 1.2 seconds consisting of an ON (0.6-second) – OFF (0.6-second) cycle. The 100th-digit numeral and lower digit numerals consist of a 0.3-second ON and 0.3-second OFF cycle.