What does SRS mean on a 2004 Honda CRV?
The car’s onboard computer will turn on the Supplemental Restraint System (SRS) Warning Light if the system will not operate properly or operate outside of intentions. This system is designed to deploy air bags and tighten seat belts when the computer determines the car is in an accident.
Why is my SRS light on Honda CRV?
If your Honda airbag light remains on, it most likely means that the Supplemental Restraint System (SRS) has detected a problem with the airbag system. When your Honda airbag system functions properly, the airbag light comes on when you turn on the ignition but should turn off once you start the engine.
How do you turn off the SRS light on a Honda CRV?
Strip the ends of both wires using a knife. Keep the ends of the wire touching while you do this. Repeat Step 3 and the SRS light will blink twice and turn off. Unshort the two wires. This will cause the SRS light to blink twice.
Is there a way to reset the SRS light?
That’s partially true; however, having the SRS light come on during Honda ownership is almost an expected thing. Having the SRS light come on is so common that the original owner’s manual actually gives a briefing on how to reset it. To do so, you will be “shorting” the system in order to reset the light.
Where is the SRS light on a Honda Accord?
It should be located near the driver’s side fuse panel under the dash. The harness is yellow with two wires. (2) Unplug the MES Plug. -Short and hold the leads while you turn the ignition to on. The SRS Light will illuminate for a few seconds then go off. -When the SRS Light goes off, unshort the wires. The SRS Light will come back on.
Why does my Honda SRS light keep blinking?
The SRS light will blink twice indicating the SRS system and the light are reset. If this procedure is followed correctly and the light remains on, then there may be an actual issue with the SRS system. In this case, it is advised to bring the vehicle to the dealership, where the trouble code can be identified and the issue repaired.
Strip the ends of both wires using a knife. Keep the ends of the wire touching while you do this. Repeat Step 3 and the SRS light will blink twice and turn off. Unshort the two wires. This will cause the SRS light to blink twice.
What should I do if my SRS light keeps coming on?
If you don’t have wires, you can use paperclips instead. Hold the ends of both wires together, and turn on the ignition. The SRS light will come on, and after a few seconds it will turn off. Once the light turns off, pull the wires apart. The light should turn back on. Hold the stripped ends of both wires together again.
It should be located near the driver’s side fuse panel under the dash. The harness is yellow with two wires. (2) Unplug the MES Plug. -Short and hold the leads while you turn the ignition to on. The SRS Light will illuminate for a few seconds then go off. -When the SRS Light goes off, unshort the wires. The SRS Light will come back on.
The SRS light will blink twice indicating the SRS system and the light are reset. If this procedure is followed correctly and the light remains on, then there may be an actual issue with the SRS system. In this case, it is advised to bring the vehicle to the dealership, where the trouble code can be identified and the issue repaired.