What does RPM sensor loss mean on generator?
The error code 1505 is a RPM loss alarm and will trigger a shutdown anytime it occurs and will not self clear. It’s a CRANKING alarm, which means that the alarm occurred during a crank cycle, NOT while the unit was actually running.
How do I reset my Generac?
Turn off the machine first. Slowly press Enter twice, then automatically turn on your device. You can expect the yellow light to flash at least once or twice a year.
How do I reset my Generac generator?
If it is a new generator, then resetting the yellow light is easy. You need to turn off the machine first. Then hit the ENTER button twice. Do it carefully and slowly.
How do you reset the alarm on a Generac generator?
If the unit was running and shuts down, attempting to restart, clear the alarm by pressing the ENTER button twice, then press AUTO. Next, remove some of the loads. Try putting it back in AUTO and then restart. If it does not start after doing this, you will need to place a service call.
What causes Overcrank on Generac generator?
The overcrank warning means the unit is trying to crank, however is not actually starting and coming up to the typical speed this generator is programmed for. Some factors that will lead to this overcrank issue will be around weak battery, gas supply issue, empty propane tank, or an incorrectly installed generator.
How do you fix an Overcrank on a generator?
Overcrank, Code 1100– If your home standby is displaying this error code, resetting the controller and restarting your unit may do the trick. If your unit does not start after two automatic attempts, there is an issue. Make sure the gas to your generator is turned on.
How do I reset my red Generac generator?
How to reset the red light on a Generac generator – Quora. > To reset the Maintenance Due light, the generator must be in OFF mode. Set the Generator to OFF and press the OFF button to reset Maintenance Due. If an alarm condition exists, the alarm condition must be cleared prior to resetting the Maintenance Due light.
Why is my Generac Power Controller showing an error code?
A sudden drop in voltage can set off this error code. For this code, a service call is needed. Your unit shows this code when you controller senses an overload condition. The first thing to do is remove the load. Load shedding should be installed to prevent this from happening in the future.
What should the voltage be on a Generac battery?
If the voltage is less than 12.5 VDC, recharge the battery. If the voltage is over 12.5 VDC, check the charge circuit for operation. Looking for more? In Generac’s Online Product Support section you can find the specifications, product manuals, frequently asked questions, how-to videos, and more for your product.
What should I do if my Generac generator stalls?
The unit re-cranks 5 times, when load is applied the engine stalls (0 RPM) and has low output voltage (< 180VAC) The unit is most likely overloaded and load should be removed to prevent damage. Inspect the stepper motor and linkage to make sure it’s not binding or stuck.
Why is my home standby generator not starting?
If your home standby is displaying this error code, resetting the controller and restarting your unit may do the trick. If your unit does not start after two automatic attempts, there is an issue. Make sure the gas to your generator is turned on. If the handle is lined up with the pipe, your gas is on.