What does it cost to replace a power window regulator on a Pontiac Sunfire?

A door window may move slowly or stop in mid travel due to a failing power window motor. The affected window may start working again after the motor cools off. Replacing the faulty window motor will commonly correct this concern. The average cost for a Pontiac Sunfire Window Regulator Motor Replacement is between $138 -$237.

Why is the power window on my Sunfire not working?

Is there a recall on the Pontiac Sunfire?

People have numerous problem with power windows in this model. Unaware if there is a recall? Unaware if a 2005 Pontiac sunfire on windows is still authorized even. Driver’s side window would slowly come down and would take a few minutes for it to go a few inches at a time up again.

How to close a power window manually in a car?

Here are the steps to close your power window manually. Remove the door panel. Disconnect the window from the motor. Access and disengage the motor. Reconnect the window to the motor and raise. Replace the door panel. This article is accurate and true to the best of the author’s knowledge.

Why is the left power window not going up?

Since about 100,000 miles have had power windows stall for a while but fore going up. Dealt with left and right windows at various times. Right power window motor has completely stopped. I know switches on console have been replaced and will move left window somewhat. It appears to be the motor.

How to raise power window manually in a car?

Reconnect the Window With the Motor and Raise In this step, you will reconnect the window to the mechanism, raise it by hand most of the way up, and then by re-engaging and turning the motor the last part of the way. Grab the window from above (and below), and remove the wooden brace holding it up.

How to raise a stuck power window manually in a car?

When you unscrew them, be sure to hold the window so that it won’t accidentally fall off the regulator mechanism’s ledge (this is an extra precaution). Move the window up: While holding the window in place with one hand below, grab the top of the window and pull it up as high as you can.

Why does my car window roll up faster than it should?

When the motor begins to fail, or if there is an electrical problem with the regulator assembly, it can cause the window to roll up slower or faster than it should. When you notice this warning sign, contact a mechanic so they can diagnose the precise problem with the power windows.

Can a power window be repaired on a late model car?

Fortunately, power windows are usually one of the more reliable systems on a late-model car. And diagnosis and repair are usually pretty straightforward. What’s Up? The most common power window mechanism is pretty basic. There’s a simple regulator mechanism, usually similar to the mechanism used on garden-variety hand-cranked windows.

Why is my window switch not working properly?

It also might be an issue with the switch itself, which is why you should contact an experienced and local ASE certified mechanic to inspect this problem before you assume it’s the window motor/regulator assembly that needs to be replaced. In some cases it could simply be debris that is trapped under the switch that is causing the problem. 2.

How do you change a power window motor?

Move the window if necessary to access the bolts. In some cases, you may need to raise or lower the window in order to access the bolts. Turn the key in the ignition of the vehicle without starting the engine to move the window if need be. Raise or lower the window using the power window buttons if possible.

How to install a new power window motor?

Installing a New Power Window Motor 1 Slide the new motor and regulator back into place. Insert the power window motor and regulator back into the main service port in the door in exactly the opposite order that you removed them in when disassembling the door.

Navigation