What does FMI stand for in failure mode?
•“FMI” is the Failure Mode Indicator. This number represents the type of failure detected. Refer to Failure Mode Indicators (FMI) below for more information. 2 BODY CONTROLLER DIAGNOSTIC TROUBLE CODES (S08327) FAILURE MODE INDICATORS (FMI) DEFINITIONS
Which is the correct SPN 91 or 974?
NOTE—See SPNs 91 and 974 for additional accelerator position parameters. 30 Engine Crankcase Blowby Pressure 31 Transmission Range Position Not referenced in J1939-71 32 Transmission Splitter Position The current position of the splitter cylinder. 33 Clutch Cylinder Position Not referenced in J1939-71 36 Clutch Plates Not referenced in J1939-71 37
When to use SPN 3609 for aftertreatment?
Aftertreatment 1 Diesel Particulate Filter Intake Pressure (use SPN 3609) Exhaust pressure as a result of particle accumulation on filter media placed in the exhaust stream. It is recommended that SPN 3609 be used as it has better resolution. 82 Engine Air Start Pressure
What is the Suspect Parameter Number ( SPN )?
The Suspect Parameter Number (SPN) is diagnostic fault code terminology found on some Caterpillar ® products using a J1939 CAN data link.
What does SPN stand for on a body controller?
DEFINITIONS •“SPN” represents the Suspect Parameter Number. This number identifies the item for which diagnostics are being reported. •“FMI” is the Failure Mode Indicator. This number represents the type of failure detected. Refer to Failure Mode Indicators (FMI) below for more information. 2 BODY CONTROLLER DIAGNOSTIC TROUBLE CODES (S08327)
What are the SPN codes for a Malibu boat?
SPN Codes and Page Numbers Sorted by SPN SPN FMI Description Page # SPN29 FMI 3 FPP2 Voltage High (pedal position sensor) 344 SPN 29 FMI 4 FPP2 voltage low (pedal position sensor) 342 SPN 51 FMI 0 TPS1 % Higher Than TPS2 % 73 SPN 51 FMI 1 TPS1 % Lower Than TPS2 % 43 SPN 51 FMI 3 TPS1 Signal Voltage High 47
FMI” is the Failure Mode Indicator. This number represents the type of failure detected. Refer to Failure Mode Indicators (FMI) below for more information. Active” or “Previously Active” will be displayed to identify whether a fault is currently active or if the fault was previously active.
What does FMI stand for on a truck?
FMI= 3 VOLTAGE ABOVE NORMAL OR SHORTED TO HIGH SOURCE. SPN105 INTAKE MANIFOLD TEMP. FMI= 4 VOLTAGE BELOW NORMAL OR SHORTED TO LOW SOURCE. SPN 94 FUEL DELIVERY PRESSURE. SID 146 EXHAUST GAS RE-CIRCULATION VALVE MECHANISM. Any help would be appreciated. Every month 400 people find a job with the help of TruckersReport. Please Select…
What is the ICP on an international dt466e?
The icp is between 800 and 900 psi while cranking, fuel pressure is I have an international dt466e that will not start. The icp… HeavyEquipmentTech : Hi my name is***** will try to help.