What does AT Oil Temp mean SUBARU Legacy?
The AT oil temperature warning light “AT OIL TEMP” illuminates when the ignition switch is turned to the “ON” position and turns off after approximately 2 seconds. If this light illuminates when the engine is running, it may indicate that the transmission fluid temperature is too hot.
How do you check the transmission fluid in a SUBARU Outback?
Automatic Transmission Fluid Park on a level surface and set the parking brake. Shift the selector level in each position. Then shift it in the “P” position, and run the engine at idling speed. Pull out the dipstick and check the fluid level on the gauge.
Why is my SUBARU oil light on?
It Could Indicate Low Oil Level The oil warning light could also indicate that your Subaru vehicle’s oil level is low. You should check your oil level right away if the light is on. To do so, remove the dipstick, wipe it off with a cloth, reinsert it, and pull it out again.
What happens when the at oil temp light is flashing?
Running the car engine when the at oil temp light is flashing can lead to transmission failure causing the vehicle more damage. And trust me you don’t want to experience a Transmission failure because, as they are extremely expensive to fix or repair.
What causes the IAT temp light to flash?
Subaru AT (Automatic Transmission) oil Temp Light flashing may be caused by different factors. The IAT temp light will flash if there was an electrical fault in the tranny at some stage in the last manoeuvre.
Why does my Subaru at oil temp light come on?
The Subaru at oil temperature light coming on when driving or while the car engine is running simply means or indicates that the fluid temperature of the automatic transmission is too hot or higher than normal.
What does the Sabaru at oil temp light mean?
The AT oil temp light is intended or devised to automatically flash warning light when there is a fault in the Subaru car computer system or if it is malfunctioning what so ever. The Sabaru AT oil temp light may come on at different cases. Sabaru AT Oil Temp Light Flashing
Why does the oil temp light keep flashing?
There is a way to read a “code” off the flashing a/t oil temp light, that code will tell you if it’s the TPS 90 people found this helpful. At light just recently came on flashing . Seems to only happen when engine is heated up. 2.2 suburu 1999 Impreza and when turning a sharp corner skipping/ surging what maybe the main problem?
What should I do if my oil light is blinking?
What I would do is with the engine idling, wiggle the wire plug at the oil pressure switch and see if the light does flicker off and on, so you may need a helper. Then next if it does not is to check the actual oil pressure with a gauge and see if the pressure is truly fluctuating. If so, the problem is most likely with the oil pump.
What to look for at the oil temp light?
Look for obvious leaks around the transmission, near the radiator and if your vehicle has a secondary trans oil cooler.. check that too. 64 people found this helpful. Can also be throttle position sensor going out. There is a way to read a “code” off the flashing a/t oil temp light, that code will tell you if it’s the TPS
The Subaru at oil temperature light coming on when driving or while the car engine is running simply means or indicates that the fluid temperature of the automatic transmission is too hot or higher than normal.