What do you need to replace CV joint in Mazda?
If you plan on replacing it yourself, you will need a torque wrench, or strong breaker bar, and sockets to break the main CV joint lock-nut loose because it’s extremely tight. Be prepared to have to take the lower ball joint out too and that’s difficult without the right tools.
What to do when you remove axle from CV joint?
It’s normal for some transmission fluid to leak out as you remove the axle from the cv joint. You should put down a catch pan. On your vehicle, the axle may have to pass through an enclose piece called a wishbone before it’s completely free. You can remove the band from the inner boot to help the old axle pass through.
How do you replace a CV axle on a Mazda 3?
There are two ways of doing this, the first way is to pop the ball joint on the lower control arm out of the spindle and pull the wheel hub and entire suspension away from the car so the axle pops out of the hub. Ideally, this is the easiest way of doing it, since it only requires the removal of 1 bolt on the spindle to free the ball joint from it.
How do you remove the hub from a CV axle?
Tape the steering knuckle joint with a hammer (hitting the knuckle where the rod goes through and not the threaded portion of the tie rod) to help remove it. Unbolt the hub from the strut tower.
Why do you need CV joints in a Mazda?
Most rear wheel drive or 4WD cars also have CV joints They are needed to transfer torque from the transmission to the wheels on your Mazda at a constant speed – while also accommodating the up and down motions that go through the suspension. In front wheel drive Mazdas, CV joints deliver torque to the car’s front wheels during turns.
Can a CV axle be removed from a Mazda 6?
This step only applies to the passenger side CV Axle. It is easiest for most people to remove the intermediate shaft and the CV axle while they are still connected to each other. Then, you can put the intermediate shaft in a vise, and hammer out the CV axle.
How to replace the right side drive shaft on a Mazda 3?
The right-side drive shaft of MZR 2.3 DISI Turbo equipped vehicles cannot be disassembled. Therefore, replace the front drive shaft as a single unit if there is any malfunction of the boots, boot bands, or constant velocity joints. 1. Remove the aerodynamic under cover No.2 and splash shield as a unit.. 2. Drain the transaxle oil or ATF.. 3.
Where are the CV joints on a front wheel drive car?
There are two types of CV joints: Every front wheel drive car has a CV, or constant velocity, joint on both ends of the driveshafts. The inner CV joints connect the driveshaft to the transmission, and the outer CV joints connect the driveshafts to the wheels.