What do you need to know about the p0507 code?

What do you need to know about the p0507 code?

The P0507 code is a common code for vehicles equipped with an electronic throttle body. Newer vehicles do normally use an electronic throttle body. An electronic throttle body is just like it sounds, it’s electronic instead of the old throttle bodies with wires between the gas pedal and the throttle body.

What does ECM do on Honda p0507?

P0507 Honda Description. The Engine Control Module (ECM) controls the engine idle speed to a specified level through the fine adjustment of the air, which is let into the intake manifold, by operating the electric throttle control actuator.

How much does it cost to repair a Honda p0507?

3. Let the engine idle for 10 minutes with the throttle fully closed. The cost to diagnose the P0507 HONDA code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

Why does the idle go up after cleaning the throttle body?

The idle is going to be high at first until the computer relearns the idle again. Cleaning the throttle body allowed more air to enter the engine, and the computer is compensating by adding more fuel.

The P0507 code is a common code for vehicles equipped with an electronic throttle body. Newer vehicles do normally use an electronic throttle body. An electronic throttle body is just like it sounds, it’s electronic instead of the old throttle bodies with wires between the gas pedal and the throttle body.

When is the p0507 idle air control system higher than expected?

In this case, the P0507 DTC (diagnostic trouble code) is triggered when the PCM (powertrain control module) detects an engine idle speed that is greater than the desired (pre-programmed) RPM.

What is the idle control system RPM code?

The P0507 code is a common code for vehicles equipped with an electronic throttle body. Newer vehicles do normally use an electronic throttle body.

Can You Spray throttle body cleaner on the intake manifold?

Do NOT EVER spray throttle body cleaner directly onto the throttle plate. The cleaner can wick into the electronics and damage them. Once the throttle body has been cleaned, reinstall on the intake manifold using a new gasket and proper torqueing procedures. Then perform an idle relearn procedure.

Why does my DTC p0507 have idle speed control?

Depending on year, make, and model, DTC P0507 may have number of causes. Here are some of the most common. ECU Update – Newer vehicles, particularly those with drive-by-wire electronically-controlled throttle bodies, may not be equipped with an individual IAC, but use the main throttle valve to maintain idle speed.

The P0507 code is a common code for vehicles equipped with an electronic throttle body. Newer vehicles do normally use an electronic throttle body.

Is there a way to reset the throttle body?

This method is almost foolproof as long as all ECU control parameters are within their normal ranges. Resetting The Throttle Body Calibration (this step is conditional) A Rough Idle or a SES can sometimes be caused by a change in the throttle body position sensor calibration.

When to use the p0507 code on your car?

The P0507 code is triggered when the Engine Control Module ( ECM) detects that the engine is idling higher than the specified idle rpm range. The standard engine idle is usually between 600-800rpm based on the model of the vehicle.

Depending on year, make, and model, DTC P0507 may have number of causes. Here are some of the most common. ECU Update – Newer vehicles, particularly those with drive-by-wire electronically-controlled throttle bodies, may not be equipped with an individual IAC, but use the main throttle valve to maintain idle speed.

What should I do after replacing my throttle body?

After replacing the throttle body to your engine, if the engine light was on and has a pending code, the code will go away. If the code was a hard permanent code, then the ECM (computer) would need a hard reset. Remove the negative battery cable (-) and keep it off for about 13 minutes, then hook up the battery cable and make sure it is tight.

How to reset throttle body calibration [ step by step guide ]?

Make sure that the accelerator pedal is fully released. Turn ignition switch “ON” and wait at least 2 seconds. Turn ignition switch “OFF” wait at least 10 seconds. Turn ignition switch “ON” and wait at least 2 seconds. Turn ignition switch “OFF” wait at least 10 seconds.

In this case, the P0507 DTC (diagnostic trouble code) is triggered when the PCM (powertrain control module) detects an engine idle speed that is greater than the desired (pre-programmed) RPM.

Can a Chevy Silverado p0507 take off faster?

It is common to feel the whole vehicle jerk when put into gear with P0507. Vehicle Takes off Faster – With the engine idling higher, people report feeling the vehicle take off when releasing the brake pedal. This can make driving more dangerous.

What does DTC stand for on Nissan p0507?

They rely on sensors and electronics to control the throttle. In this case, the P0507 Nissan DTC (diagnostic trouble code) is triggered when the PCM (powertrain control module) detects an engine idle speed that is greater than the desired (pre-programmed) RPM.

When does the idle control system code p0507 occur?

The P0507 trouble code is being triggered when the idle control system RPM is Higher than expected. All modern engines do have a desired idle rpm, usually between 600-1000 rpm.

What do you need to know about DTC p0507?

When diagnosing DTC P0507, you’ll want to focus on the air intake system, particularly the throttle body, IAC, and intake manifold. Pay attention to concurrent DTCs, which could also point you to a solution.

What does the p0507 code on the ECM mean?

What Does P0507 Mean? The P0507 code is triggered when the Engine Control Module ( ECM) detects that the engine is idling higher than the specified idle rpm range. The standard engine idle is usually between 600-800rpm based on the model of the vehicle.

What causes a p0507 code on a Chevy Silverado?

The Idle Air Control Valve is often not the cause of the code. Here are some of the most common causes of P0507 in the Chevy Silverado, as well as waist to troubleshoot them. Keep in mind that there are differences in model years.