What do you need to know about a Mazda Protege?
Preparing document for printing… Specifications Engine Control Module: Specifications PCM INSPECTION CAUTION: The PCM terminal voltages vary with change in measuring conditions and vehicle conditions. Always carry out a total inspection of the Input systems, output systems, and PCM to determine the cause of trouble.
How to remove the cylinder switch from a Mazda Protege?
ECT sensor signal characteristic (reference) Circuit Open/Short Inspection fPage 210 Door Lock Cylinder Switch: Service and Repair DOOR KEY CYLINDER SWITCH REMOVAL/INSTALLATION 1. Close the door glass completely. 2. Disconnect the negative battery cable. 3. Remove the passenger-side front door trim.
How to change the ECT sensor on a Mazda Protege?
Place the ECT sensor in water with a thermometer, and heat the water gradually. Specification 4. Measure the resistance between the ECT sensor terminals A and B using an ohmmeter. – If not as specified, replace the ECT sensor.
How to replace the sunroof relay on a Mazda Protege?
– If not as specified, replace the relay. fPage 37 fSunroof / Moonroof Relay: Service and Repair fSUNROOF RELAY REMOVAL/INSTALLATION NOTE: Sunroof relay is built in the sunroof motor. fTesting and Inspection Daytime Running Lamp Control Unit: Testing and Inspection DRL CONTROL MODULE INSPECTION (CANADA) 1.
Preparing document for printing… Specifications Engine Control Module: Specifications PCM INSPECTION CAUTION: The PCM terminal voltages vary with change in measuring conditions and vehicle conditions. Always carry out a total inspection of the Input systems, output systems, and PCM to determine the cause of trouble.
ECT sensor signal characteristic (reference) Circuit Open/Short Inspection fPage 210 Door Lock Cylinder Switch: Service and Repair DOOR KEY CYLINDER SWITCH REMOVAL/INSTALLATION 1. Close the door glass completely. 2. Disconnect the negative battery cable. 3. Remove the passenger-side front door trim.
What is the coolant temperature sensor on a Mazda Protege?
Vacuum hose fPage 241 fEngine – Coolant Temperature Sensor/Switch: Testing and Inspection fENGINE COOLANT TEMPERATURE (ECT) SENSOR INSPECTION NOTE: Perform the following test only when directed. ECT Sensor Resistance Inspection 1. Drain the engine coolant. 2. Remove the ECT sensor. 3.
Place the ECT sensor in water with a thermometer, and heat the water gradually. Specification 4. Measure the resistance between the ECT sensor terminals A and B using an ohmmeter. – If not as specified, replace the ECT sensor.